Panasonic CY-TUN153U - Manual (Page 11)

20
English
CY-TUN153U 21
English
CY-TUN153U
No. Item Diagram Qty.
 Power Connector
(YEAJ012884) 1
 Head Unit/Expansion
Module Connecting
Cable
(3 m)
(YEAJ071812)
(for Expansion Module) 1
 RCA Cord (3 m)
(YEAJ071819)
(for video connector) 1
 RCA Cord (3 m)
(YEAJ071820)
(for audio connector) 1
 RCA Cord (3 m)
(YEAJ071821)
(for remote control
connector) 1
 Clip Connector
(YEAT034C012) 1
Installation
Installation Precautions
This unit should be installed by a professional installer.
In case of diffi culty, please consult your nearest
authorized Panasonic Servicenter.
 This system is to be used only in a 12 V DC battery
system (car) with negative ground.
 Follow the electrical connections carefully (page 26).
Failure to do so may result in damage to the unit.
 Connect the power lead after all other connections are
made.
 Be sure to connect the battery lead (yellow) to the
positive terminal ( ) of the battery or fuse block (BAT)
terminal.
 Insulate all exposed wires to prevent short circuiting.
 Secure all loose wires after installing the unit.
 Please carefully read the operating instructions of the
respective equipment before connecting it to this unit.
Installation Hardware
(For Installation)
No. Item Diagram Qty.
 Tapping Screw
(
516 mm)
(XTT5 16AFZ)
4
 Velcro Tape
(YFX994C135ZA) 2
Installation Hardware
(For Wiring)
Note:
 The number in parenthesis underneath each accessory
part name is the part number for maintenance and
service.
 Accessories and their parts numbers are subject to
modifi cation without prior notice due to improvements.
 Use the supplied screws for installation exclusively. In
case of losing any of them, please order the specifi c
screw.
19 20
Preparation
Caution
 Please follow the laws and regulations of your
province or country for installation of the unit.
 We strongly recommended you to wear gloves for
installation work to protect yourself from injuries.
 Disconnect the cable from the negative () battery
terminal (see caution below).
Caution
 If your car is equipped with air bag and/or anti-
theft systems specifi c procedures may be required
for connection and disconnection of the battery to
install this product.
 Before attempting installation of this electronic
component contact your car dealer or manufacturer
to determine the required procedure and strictly
follow their instructions.
 FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
AND PERSONAL INJURY.
 Antenna Clamp 4
 Cord Clamp (for antenna) 4
(YEP9FZ3041)