Pentair EasyTouch 8 and 4 Pool and Spa Control System - Manual (Page 5)

iii
EasyTouch Load Center Installation Guide
IMPORTANT SAFETY PRECAUTIONS
(Continued)
WARNING To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
WARNING The use of alcohol, drugs, or medication can greatly increase the risk of
fatal hyperthermia in hot tubs and spas.
WARNING Control System is intended to control heaters with built-in high limit circuits ONLY.
Failure to do so may cause property damage or personal injury.
WARNING Do not use this product to control an automatic pool cover. Swimmers may
become entrapped underneath the cover.
WARNING For units intended for use in other than single-family dwellings, a clearly labeled
emergency switch shall be provided as part of the installation. The switch shall
be readily accessible to the occupants and shall be installed at least
10 feet (3.05 m) away, adjacent to, and within sight of, the unit.
CAUTION Except for listed spa-side remote controls, install a minimum of five (5) feet from
the inside wall of the pool and spa.
FCC Standard - 47 CFR Part 15, Subpart C (Section 15.247). This version is limited to chapter 1
to chapter 11 by specified firmware controlled in the U.S.A.
Canada - Industry Canada (IC) - The IntelliChlor device complies with RSS210 of Industry
Canada. (1999). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Instruction to user - The IntelliChlor device has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. The IntelliChlor device
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by switching the device off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: The user is cautioned that changes and modifications made to the IntelliChlor device without
the approval of the manufacturer could void the user’s authority to operate this equipment.