Installation and connections – Pioneer PDP 503CMX User Manual

Page 17

Advertising
background image

11

En

Installation and Connections

Français

English

Installation using the optional PIONEER stand or
installation bracket

÷ Please be sure to request installation or mounting of this unit

or the installation bracket by an installation specialist or the
dealer where purchased.

÷ When installing, be sure to use the bolts provided with the

stand or installation bracket.

÷ For details concerning installation, please refer to the

instruction manual provided with the stand or installation
bracket.

Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)

÷ When possible, please install using parts and accessories

manufactured by PIONEER. PIONEER will not be held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.

÷ For custom installation, please consult the dealer where the

unit was purchased, or a qualified installer.

Wall-mount installation of the unit

This unit has been designed with bolt holes for
wall-mount installation, etc. The installation holes that can
be used are shown in the diagram below.

÷ Be sure to attach in 4 or more locations above and

below, left and right of the center line.

÷ Use bolts that are long enough to be inserted 1/2 inch

(12 mm) to 11/16 inch (18 mm) into the main unit from
the attaching surface for both a holes and b holes.
Refer to the side view diagram below.

÷ As this unit is constructed with glass, be sure to install

it on a flat, unwarped surface.

Installation and Connections

Center line

b hole

b hole

Rear view diagram (PDP-433CMX)

b hole

Center line

b hole

a hole

a hole

Air vents (fan)

CAUTION

To avoid malfunction, overheating of this unit, and

possible fire hazard, make sure that the vents on the
main unit are not blocked when installing. Also, as hot

air is expelled from the air vents, be careful of

deterioration and dirt build up on rear surface wall, etc..

CAUTION

Please be sure to use an M8 (Pitch = 1.25 mm)
bolt. (Only this size bolt can be used.)

CAUTION

This display unit weighs at least 67 lbs (30 kg)

and has little front-to-back depth, making it very

unstable when stood on edge. As a result, two
or more persons should cooperate when

unpacking, moving, or installing the display.

CAUTION

This unit incorporates a thin design. To ensure
safety if vibrated or shaken, please be sure to

take measures to prevent the unit from tipping

over.

b hole

Main unit

b hole

Center line

b hole

b hole

b hole

b hole

Center line

a hole

b hole

Bolt

Bolt

Attaching surface

Installation
bracket, etc..

1/2 inches (12 mm) to
11/16 inches (18 mm)

1/2 inch (12 mm) to 11/16 inch (18 mm)

Rear view diagram (PDP-503CMX)

Side view diagram

a hole

a hole

Air vents (fan)

Advertising