Panasonic WV-CW474S - Manual (Page 12)

2. Unscrew the red screw for
transport protection with a
Phillips screw driver.
3. Connect the power cable and the
BNC plug of the video output
cable as described in the section
"CONNECTIONS".
Loosen three
screws.
Insulate the three connecting leads of the power cords from one another, and cover the
connecting portions with insulating tape as well as the portions between the video out-
put cable and the BNC connector and between the BNC connectors to prevent the por-
tions from water immersion.
■ How to mount the camera
1. Remove the dome cover from the
main body by loosening the three
dome cover mounting screws.
The dome cover is fixed with tamperproof
screws.
Loosen the three dome cover mounting
screws by using the supplied bit for tam-
perproof screw.
Shown figure is an example for junction box.
Camera mounting screw x 4 (supplied)
Seal the screws and screw holes with such a material as silicone
clay (rubber) to prevent water immersion if the camera is installed
in the outdoor.
46 mm
(1-13/16")
83.5 mm
(3-5/16")
4. Secure the camera with four camera mounting screws.
• For WV-CW474F
Secure the camera on the junction box with four camera mounting screws.
The four camera mounting screws are not supplied. Please take note that you should
purchase the screws in accordance with the tapped holes of the junction box.
The mounting holes of this unit accept M4 or less screws.
Camera mounting screw x 4
(procured locally)
Loosen the dome
cover mounting
screw x3
• The camera mounting bracket is not designed for waterproof.
Insulate the three connecting leads of the power cords from one another, and cover the
connecting portions with insulating tape as well as the portions between the video out-
put cable and the BNC connector and between the BNC connectors to prevent the por-
tions from water immersion.
• For WV-CW474S
Secure the camera on the camera mounting bracket mounted on a wall or ceiling.
Power cord
Video output cable
Power cord
Video output cable