Paxar J640 - Manual

J640/J641 Operator’s Handbook Addendum
This addendum describes how to load continuous strip labels into
your printer and how to clean your printer using the cleaning pen
provided. Read this addendum and store it with your Operator’s
Handbook.
Loading Continuous Supplies –––––––––––––––––––––––––––––––––
Use only paper labels when using this loading method. Also, before
loading labels, make sure the label path is clean. See Chapter 4,
"Care and Maintenance," in your
Operator’s Handbook .
First follow steps 1-4 of "Loading for Peel Mode," in Chapter 2 of
your
Operator’s Handbook . After you complete step 4, follow the
steps below:
1. Feed 4"-5" of the label strip
through the upper opening in
the label guide (Figure 1).
2. Close the printer.
3. Separate the label from the
backing paper (Figure 2).
4. Use the tear bar to tear the
label so it is square with the
backing paper. Don’t tear the
backing paper (Figure 2).
5. Open the printer.
6. Pull the backing paper out of
the upper opening in the label
guide and feed it through the
lower opening.
7. Back up the leading edge of
the label so it rests 1"-2"
behind the black rubber roller.
Lower
Opening
Label
Guide
Upper
Opening
Figure 1
118169 10/95 © 1995 Monarch Marking Systems, Inc. All rights reserved.
Label
Tear
Bar
Backing
Paper
Figure 2