Peavey 6505+ - Manual (Page 8)

1 2 3 4 5 6 7 8 9 10 11 12
8
POWER SWITCH
This two-way toggle switch applies mains power to the unit.
STANDBY SWITCH
This two-way toggle switch allows the amp to be placed in the STANDBY mode. In the STANDBY position the
tubes stay hot but the amplifier is not operational. Switching to the ON position places the amp in active
mode.
LEAD CHANNEL RESONANCE CONTROL
Adjusts the low-frequency damping factor of the power amplifier, which gives the amp a "tighter" sound
when fully dialed counter clockwise and an increasingly "looser" sound when adjusted clockwise.
LEAD CHANNEL PRESENCE CONTROL
Adjusts the high frequency damping factor of the power amplifier, which gives the amp a "mellow" character
when fully counter-clockwise and more of "biting" or forward character when rotated clockwise.
RHYTHM CHANNEL RESONANCE CONTROL
Adjusts the low-frequency damping factor of the power amplifier, which gives the amp a "tighter" sound
when fully dialed counter clockwise and an increasingly "looser" sound when adjusted clockwise.
RHYTHM CHANNEL RESONANCE CONTROL
Adjusts the high frequency damping factor of the power amplifier, which gives the amp a "mellow" character
when fully counter-clockwise and more of "biting" or forward character when rotated clockwise.
MASTER REVERB CONTROL
Controls the amount of spring reverb in the signal chain.
LEAD CHANNEL POST CONTROL
This control adjusts the volume of the lead channel.
HIGH CONTROL
This passive control regulates the high frequencies for the Lead channel.
MID CONTROL
This passive control regulates the mid frequencies for the Lead channel.
LOW CONTROL
This passive control regulates the low frequencies for the Lead channel.
PRE GAIN CONTROL
Adjusts the amount of gain in the Lead Channel. Turning this knob clockwise will increase the amount of
distortion present in the signal.
LEAD CHANNEL INDICATOR LIGHT
This light is on when the Lead Channel is active.
Front Panel
1
2
3
4
5
6
7
8
9
10
11
12
13
13