Panasonic TY-WK5P1SW - Manual (Page 4)

4
English
Fitting procedure [Never use any other method than specified to
install.]
1. Assembling the wall-
hanging bracket
1. Remove the screws for securing the
bracket base left ッ and right ツ fittings.
2. Lay the base upper and lower fittings ヂ
and the bracket base left and right fittings
ッ and ツ as shown in the figure.
3. Fit the tabs of the bracket base left and
right fittings into the cutouts of the base
upper and lower fittings above, and secure
them using the two screws
ヅ used to
assemble the bracket.
(Tightening torque: 1.2 to 1.5 N•m)
4. Open slightly the bottom of the bracket
base left and right fittings, and fit their
tabs into the cutouts of the base upper
and lower fittings, and secure them using
the two screws
ヅ used to assemble the
bracket.
(Tightening torque: 1.2 to 1.5 N•m)
5. Tighten the screws for securing the bracket
base left ッ and right ツ fittings which were
loosen in step 1.
Note
• Please hold the bracket base left and right
fittings as you work with the assembled wall
hanging bracket. Holding the base upper and
lower fittings might deform this unit.
Bracket base
right fitting
ツ
Base upper and lower fittings ヂ
Base upper and lower fittings ヂ
Tab
Cutout
Bracket base left
fitting
ッ
M5x10 screws for
assembling the fixture
ヅ
Screw for securing the
bracket base fitting
Inside : 46-inch model
Outside : 50 or 54-inch
model
2. Checking the strength of the
installation location
1. The wall-hanging bracket weighs approximately 2.3 kg
(5.1 lbs).
Refer to the instruction manual of the plasma TV, and check
the weight of the plasma TV unit which will be fitted into the
wall-hanging bracket.
2. Refer to the outline drawing of the wall-hanging bracket
shown on the right, and check the wall strength at the six
installation positions shown. If the strength at any of these
positions is lacking, provide sufficient reinforcement.
Unit: mm (inches)
600 (23.6)
440
(17.3)
80
(3.1)
80
(3.1)
516 (20.3)
42
(1.7) 42
(1.7) 5
9
.5
(2
.3
)
1
7
.5
(0
.7
)
3
2
5
(1
2
.8
)
Wall mounting holes (at 6 points)
Use the screws without fail to anchor the fixture.
Notes
• There are five pre-drilled mounting holes at the top and another
five at the bottom of the wall-hanging bracket.
Use the spare holes provided if wood or some other material is
used for the wall and a sufficient level of mounting strength cannot
be ensured by anchoring the fixture at the six positions shown on
the right.
However, bear in mind that, depending on which materials the
mounting surface is made of, cracks may form on the surface if the
screws are used at positions which are too close together.
• Mount or place only a plasma TV on the fixture: Do not mount or
place any other product.
• For details on the dimensions applying when the plasma TV is
mounted, refer to the outline drawing (See back cover).