Panasonic KX-PW88CL - Manual (Page 20)

20
Using the hand scanner
Scanning a document
F 2
1
Press down the knob of the
hand scanner, and pull out the
scanner from the main unit.
Then, turn it over.
2
Press (Resolution) repeatedly
to select the desired resolution.
● Resolution types
(Standard : For printed or typewritten originals
with normal-sized characters)
(Fine : For originals with minute printing)
(Photo : For originals containing photographs)
3
Press (Select) repeatedly
to select the desired width.
● Scanning width types
A4 (Within 208mm)
B4 (Within 252mm)
F 2
4
Place the scanning position and the
(Document’s left end) on the document.
5
Press (Start).
● When you hear a beep, you can start scanning.
Knob
(Document’s
left end)
(Scanning
position)
6
Press the hand scanner against the document, and
move it slowly towards the direction of the arrow ( ).
● For the proper scanning speed for different
resolution types, see “Scanning speed and memory
capacity” on the bottom of this page.
● When the hand scanner is moved quickly, a beep
will sounds and the following will be displayed.
7
After scanning the document, press (Stop).
● You will hear a beep, and the scanned document is
stored in memory of the main unit. Only 1 page can
be scanned.
Scanning speed and memory capacity
Scanning direction
(Bottom side)
Resolution
Scanning width
Standard
Scanning speed
100mm/sec
Fine 50mm/sec
Photo 25mm/sec
Resolution type
A4
Memory capacity
Max. Approx. 2 pages (A4)
B4 Max. Approx. 1 page (B4)
Scanning width type
8
To print the scanned document or to send it by fax,
see the next page.
● If you make a mistake, press (Stop) to erase
the content of the memory, then start from step 2.
Important:
● When you have completed scanning, the scanned
document in memory will be automatically erased after
10 minutes.
● To reinsert the hand scanner into the main unit, turn the
scanner over, and insert it into the main unit firmly.