Patriot Products Patriot 3.8m Commercial Antenna King Post Mount User Manual
Page 12
12
NOTE:
Radial Beam between
panel flanges!
5. Set in place 2 Panels into the Radial Beams. The Radial Beam will be between the fl ange
of each Panel (see below). Using 3 tapered alignment tools- 2 in the outermost holes, and
1 in the center hole to align the holes in the panels and radial beam, install the hardware in
the remaining holes (from kit labeled- Petal to Radial Beam) starting with the hole closest
to the hub. Use 1 bolt, 2 washers, and 1 nut per hole. Pull the tapered alignment tools and
install that hardware. Leave hardware loose at this time.
Continue installing the remaining Petals using this method.
Tightening Procedure- Important!
6. Starting at the Hub tighten all hardware by working outward 1 circular row at a time.
7. When all petals are tight put in the remaining hardware from the Outboard Skirt
pack. At every 4th Radial Beam/Outboard Skirt junction include an Outboard Feed
Angle as you assemble using hardware kit labeled- Feed Strut Bottom. Tighten hard-
ware as you intall it.
NOTE:
The 3 holes in Outboard Feed Angle should be aligned with the 3 holes in
Outboard Skirt. See next page