Panasonic CQDF202 - Manual (Page 10)

E
N
G
L
I
S
H
19
E
N
G
L
I
S
H
20
CQ-DF202W CQ-DF202W
28 29
Electrical Connections Specifications
❐ Wiring Diagram
No. Item Q’ty
6 Power connector 1
Power connector
Antenna
6
CD changer control connector
CD changer CX-DP88
Battery lead
(Yellow)
Changer control DIN cord
Fuse (3 A)
(Yellow)
BATTERY 15A Battery lead
To the car battery,
continuous +12 V DC
Fuse (15 A)
(Red) Resistor (1 k≠)
ACC Power lead
To ACC power,
+12 V DC
(Dark blue)
(Black)
Ground lead
To a clean, bare metallic part of car
chassis.
L (White)
R (Red)
(r) (s) (r) (s) (r) (s) (r) (s)
Left speaker
(Front)
Right speaker
(Front)
(White) (Gray) (Green) (Violet) (White/black
stripe) (Green/black
stripe) (Violet/black
stripe) (Gray/black
stripe)
FRONT SP REAR SP
Left speaker
(Rear)
Right speaker
(Rear)
Speaker lead
Ground lead
Be sure to connect to a well
grounded metallic part of your car
because noises or troubles may
occur.
DIN extension cord (DIN/BATT/RCA/GND)
(Black)
RCA cord
Motor antenna relay control lead
(To motor antenna)
This lead is not intended for use with
switch actuated power antenna.
Amp. relay control power lead
This lead is for connection to the power
amplifier.
CQ-DF202W (rear)
L (White)
R (Red)
CD changer input connector
Preamp out connector (rear)
(Max. 500 mA)
Caution:
≥
This product is designed to operate with a 12 V DC, negative ground battery system.
≥ To prevent damage to the unit, be sure to follow the connection diagram below.
≥ Remove approximately 5 mm of protective covering from the ends of the leads before connecting.
≥ Do not insert the power connector into the unit until the wiring is completed.
≥ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
≥ Remember, if your car has a drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
Supplied hardware
❐ General
Power supply: 12 V DC (11 Vj16 V), test voltage 14.4 V, negative ground
Current consumption: Less than 2.2 A (CD play mode; 0.5 Wa4 channels)
Maximum power output: 45 Wa4 channels at 400 Hz, volume control maximum
Tone adjustment range:
Bass: n 12 dB at 100 Hz
Treble: n 12 dB at 10 kHz
Suitable speaker impedance: 4j8 ≠
Preamp output voltage:
2.0 V (CD play mode; 1 kHz, 0 dB)
Output impedance: 200 ≠
Dimensions (WaHaD): 178a50a150 mm
Weight: 1.4 kg
❐ FM Stereo Radio
Frequency range: 87.50 MHzj108.00 MHz
Usable sensitivity: 11.0 dBf. (1.25 ¨V, 75 ≠)
50 dB quieting sensitivity: 15.2 dBf. (1.6 ¨V, 75 ≠)
Frequency response: 30 Hzj15 kHz (n3 dB)
Alternate channel selectivity: 75 dB
Stereo separation:
42 dB (1 kHz)
Image response ratio: 75 dB
IF response ratio: 100 dB
Signal/noise ratio: 70 dB
❐ AM Radio
Frequency range: 531 kHzj1 602 kHz
Usable sensitivity: 28 dB/¨V (25 ¨V, S/N 20 dB)
❐ CD Player
Sampling frequency: 32 times oversampling
DA converter: MASH·1 bit/4 DAC system
Error correction system: Panasonic super decoding algorithm
Pick-up type: Astigma 3-beam
Light source: Semiconductor laser
Wave length: 780 nm
Frequency response: 20 Hzj20 kHz (n1 dB)
Signal/noise ratio: 96 dB
Total harmonic distortion: 0.01 % (1 kHz)
Wow and flutter: Below measurable limits
Channel separation: 75 dB
Note:
≥
Specifications and the design are subject to modification without notice due to improvements in technology.