PYLE Audio PYLE PylePro PDWM2200 - Manual (Page 3)

Please read and check the following points before asking for service.
The wireless microphone fails fo work:
--Check the microphone battery by switching the microphone ON. If power LED
indicator lights red, replace the battery.
--Check the POWER indicator on the receiver unit is ON. If not, check the
mains power adapter is firmly plugged into a working mains socket.
--Check the amplifier system is ON and the microphone controls set correctly.
--Check the radio microphone jack lead is firmly connected into the output
socket on the rear panel of the receiver unit and into the MIC input socket on
your amplifier.
The working range is limited:
--Check the microphone battery condition(see above)
--Check the aerials are fully extended. Adjust the position of the aerials to
achieve the best reception.
Feedback is heard:
--Check if the microphone is too close to or in front of the loudspeaker.
Check the settings of the microphone controls on the amplifier. Adjust volume
and tone to get the beat sound without any trace of feedback.
TROUBLE SHOOTING
1. Unscrew the battery cover at the end of the microphone. Install the
provided 9 volt battery and then close the cover. Make sure to connect
with the correct polarity.
2. Move power switch to ON position. Power LED indicator will flash
once and then go off. This indicates correct operation. If power LED
indicator lights red, this indicates the battery is Iow. Please replace
with new battery.
3. Move power switch to center to mute the microphone.
4. If the microphone is not going to be used for a long period of time,
please take out the battery to prevent damage by battery leakage.
HANDHELD MICROPHONE
7 2