Powermatic HPS67 - Manual (Page 16)

16
4. Record the measurement in the sight glass.
5. Add 2” to this measurement and slide out
the extension until the new measurement is
read at the end of the fixed fence (Figure
28). NOTE: Be careful to set this correctly,
because the scale on the sliding fence
reads opposite the scale on the fixed fence.
6. Lock the extension fence to this new
measurement by tightening the knob
underneath.
7. With a 3mm hex wrench, loosen the set
screws underneath the short movable fence
extrusion (Figure 29), and slide the
extrusion to 2” of the fixed fence (Figure 30).
Tighten the set screws.
8. When using the telescopic extension, make
sure the stop is positioned flush with the end
of the movable extrusion.
9. The best way to check if all scales
correspond is to make several test cuts on
the different scales.
Wood Cap
After a period of use, if the wood protection cap
at the end of the crosscut fence is cut away, a
new one must be made. See Figure 31 for the
correct dimensions.
Figure 28
Figure 29
Figure 30
Figure 31