Panasonic UB-5325 - Manual (Page 15)

Paper Jams
15
English
Remove paper jams by the following procedure when
copy paper does not come out of the output port or
when “
” flashes on the Multi-Copy/Error Indicator.
1 Push down the printer open lever to open the
printer door.
2 Remove the thermal transfer film with both
hands.
3 Remove the jammed paper.
4 Install the thermal transfer film.
• Refer to steps 3 and 4 in the section of
“Installing the Thermal Transfer Film” on
page 10.
• “ ” flashing on the Multi-Copy/Error
Indicator will go out.
Note
• If “ ” is still flashing after closing the printer
door, make sure that the thermal transfer film
has been installed properly and tightened.
• The printer door should be closed to make
copies properly. Confirm both latches are
locked.
If the flashing “ ” does not go out after the foregoing
procedure has been performed; this may indicate that
the paper feeder is not functioning properly.
Reload the copy paper by following the steps given
below.
1 Turn the power off.
2 Open the paper cover and remove all the copy
paper remaining inside the unit’s paper cover.
Note
• The copy paper will slightly resist being
removed, but may be pulled out without
problems.
Paper Jams
Jammed paper
ON
OFF