Porter-Cable 3802L - Manual (Page 7)

7
1. Carefully remove the machine from the carton. Retain all packing materials until you have inspected and
satisfactorily operated the machine.
Do not operate this machine until you read and understand the entire instruction manual.
2. Place the machine on a firm, level surface with extra room for handling and proper support of the workpiece.
3. Familiarize yourself with all features and controls explained in this manual.
4. The machine is shipped with the cuttinghead locked in the down position and the table rotated to 45° left, Fig. 2. To
release the head and move it to the operating position, see “MOVING CUTTINGHEAD TO THE UP POSITION” and
“MOVING THE TABLE TO THE 0° CUT-OFF POSITION” in this manual (Fig. 5 & 7).
Fig. 2
CARTON CONTENTS
Fig. 3
1. Miter Saw
2. Extension table
3. Fence slide
4. Fence slide support
5. Dust bag
6. 1/2" Arbor and fence wrench
7. 1/4" hex wrench
8. Open end 7/16" wrench
9. Lock handle for sliding fence
10. 5/16" flat washer
11 5/16" lock washer
12 5/16 - 18 x 1 1/4" long hex head screw (2)
13 5/16 - 18 x 3/4" long hex head screws (2)
14. 1/8" hex wrench
1 2
3
4
5
6
7
8
9
10
11
12 13
14
UNPACKING AND CLEANING
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
1/2" arbor and fence wrench (supplied)
7/16"Open end wrench (supplied)
Assembly time for this unit is approximately 30 minutes.