PSB Speakers 6919217 - Manual (Page 7)

Wall Mounting Synchrony S Surrounds
Select and install wall-mounting brackets and hardware sufficient to hold
the weight of the speakers on the walls safely.
1. Use the “3 finger” style flush mount bracket (provided in Owner's
Manual Kit).
2. The speaker should be mounted at a minimum height of five feet
measured from the bottom of the speaker to the ground. The speaker
can be mounted on the wall beside or behind the listener. Screws
with sufficient length and located to solidly enter wood are preferred.
Metal anchors, which partially collapse inside the wall, provide greater
holding power than individual screws. Screws into plastic (or metal)
shield anchors in wallboard, tile, masonry, or concrete can provide
great holding power. Do not use the simple expanding type anchors
in wallboard. These are intended for use in masonry only. If a
fastener does not tighten securely, install another, larger fastener.
3. One of the brackets has already been installed on the cabinet. Install
the other matching bracket, with the interlocking finger facing up, on
the wall. Ensure the bracket is level and aligned to the desired
position and secure in place. Use the appropriate screws/fasteners
for the type and construction of the surface, taking into consideration
the weight of the speaker.
4. Wire the speaker before mounting on the wall. Maintain electrical
polarity throughout the system. Use the following polarity indicators
as applicable: red connects to: rib/+/print/copper wire and black to
smooth/-/blank/silver wire.
5. Place the speaker against the mounting surface and slide down,
interlocking the fingers of the brackets.
6. Carefully load test the installed speaker to ensure that it is secure and
safe.
7. THE INSTALLER IS RESPONSIBLE FOR A SAFE AND SECURE
INSTALLATION.
7
O
w
n
e
r’s
M
a
n
u
a
l