Pelco Tech Tips DX4500/4600 - Manual

Tech Tech
Tips
Helpful Tips for Pelco Products
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150
International Tel: 1-559/292-1981 Fax: 1-559/348-1120
www.pelco.com Pelco and the Pelco logo are registered trademarks of Pelco, Inc.
Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 1 of 2 DX4500_4600_NO-IP.COM.fm
USING NO-IP.COM FOR DX4500/4600
WEB ADDRESS
April 10, 2008
USING NO-IP.COM FOR DDNS ON THE DX45_46 WEB ADDRESS
To change the IP address to a domain name as described in the operation/configuration manual on
page 56, follow the instructions below. If the DVR is installed in a network that has a firewall, port 8245
has to be opened to allow DDNS data to get through the firewall. For information about setting up the
firewall, refer to your network administrator or network service provider.
1. Go to www.no-ip.com and create an account.
2. Under the Hosts / Redirects panel, select Add.