Registration, To register an additional handset, Select base – Philips SE630 User Manual
Page 43: To manually select a base station, Advanced settings registration
43
EN
Advanced Settings
Registration
The procedures described below are the procedures that you will find in your SE630 handset. The procedures
may vary according to the handset you want to register. In this case, please refer to the manufacturer of the
additional handset.
Additional handsets must be registered to the base unit before you can use them. Up to 5 handsets can be
registered to one base station.
To register an additional handset
1. On the base station, press and hold
c
for 3 seconds in stand-by mode. After that, the registration
procedure has to be done within 1 minute.
2. At the same time, on the handset, press
m
MENU
, scroll
:
to
Advanced Set
and press
m
SELECT
,
scroll
:
to
Registration
and press
m
SELECT
.
3. Enter the Master PIN when prompted and press
m
OK
to start registration.
4. Press
:
to select the Base to be registered to and press
m
OK
to confirm.
A long confirmation tone is emitted to indicate successful registration and the screen returns to stand-by
mode.
Select Base
One SE630 handset can register up to 4 different SE630 Base stations. By default, the handset will register to
BASE 1. If you select
Any Base
, the handset will register to the nearest base station.
To manually select a base station
1. Press
m
MENU
, scroll
:
to
Advanced Set
press
m
SELECT
, scroll
:
to
Select Base
and press
m
SELECT
.
2. Scroll
:
to the desired base station and press
m
OK
to confirm.
3. The handset will start searching for the base station. If the selected base is found, a long confirmation tone
is emitted.
The Master PIN is required before you can register or unregister handsets. The default PIN is
0000
.
Within 1 minute, the base station is able to accept registration from a handset. If no key is pressed
within 10 seconds, the registration procedure will be aborted.
If the base is found and the PIN is correct, the unused handset numbers will be displayed and you can
select a handset number by entering the number directly.
If the PIN is incorrect,
Incorrect PIN
will be displayed and the handset returns to stand-by mode.
SE630_IFU_EN.book Page 43 Wednesday, September 20, 2006 5:58 PM