Proctor-Silex Blenders - Manual (Page 4)

7 6
7. Process food or beverages. Place hand on lid when
blending liquids. Push button on control panel to start
blender.
8. ALWAYS turn blender off and wait until blades have
stopped rotating before removing jar.
9. To remove jar after blending is complete, lift the jar
straight up. If it is not easily removed, rock gently and lift.
Do not twist.
10. NEVER replace jar onto unit while motor is running.
How to Clean the Blender
1. Unplug blender from electrical outlet.
2. Wipe blender base, control panel, and cord with a damp
cloth or sponge. To remove stubborn spots, use a mild,
non-abrasive cleanser.
3. To clean jar, unscrew retaining ring and remove cutting
unit assembly from jar.
4. Carefully remove blades and gasket from bottom of
retaining ring.
5. Carefully wash blades, retaining ring, gasket, jar (if plastic),
and cover in hot, soapy water. Rinse and dry thoroughly.
Do not soak. Do not wash blades, retaining ring, gasket,
plastic jar, or cover in a dishwasher.
6. Reassemble cutting unit assembly onto jar, replace jar
onto blender base.
7. Store blender with cover ajar to prevent container odor.
Hints for Best Use
• Processing hot foods or liquids in the blender may cause
hot liquid to spurt out when the cover is removed. Always
remove the filler-cap from the cover before blending hot
foods or liquids.
• To add foods when blender is operating, remove
filler-cap from container cover and add ingredients through
the opening.
• If blending action stops during blending or ingredients stick
to sides of the jar, turn blender OFF. Remove cover and use
a rubber spatula to push mixture toward blades.
• Do not try to mash potatoes, mix stiff dough, whip egg
whites, grind raw meat, or extract juices from fruits and
vegetables. The blender is not made to perform these
tasks.
• Do not store food or liquids in the blender jar.
• Avoid bumping or dropping the blender.
Customer Service
If you have a question about your blender, call our toll-free
customer service number. Before calling, please note the
model, type, and series numbers and fill in that information
below. These numbers can be found on the bottom of your
blender. This information will help us answer your question
much more quickly.
MODEL:_____________ TYPE:_____________ SERIES: ______________