Pitney Bowes DM200L - Manual

1 Elmcroft Road Stamford, CT 06926-0700 SV61352 Rev. B 11/04 ©2004 Pitney Bowes Inc.
This document is a publication of Pitney Bowes. The use of this information by the recipient or others for purposes other than the repair, adjustment
or operation of Pitney Bowes equipment may constitute an infringement of patent and/or other intellectual property rights of Pitney Bowes or others.
Pitney Bowes assumes no responsibility for any such use of the information. Except as provided in writing, duly signed by an officer of Pitney Bowes,
no license, either express or implied, under any Pitney Bowes or any third party’s patent, copyright, or other intellectual property rights is granted by
providing this information.
Installation Instructions
DM200L
Installing DM200L
Page 1 of 11
Remove all shipping tape attached to your meter.
Be sure to open the top cover and remove inside shipping tape.
Step 2 - Connect Phone Cord
The DM200L requires an analog phone line. Select a location
for the system near an analog phone line and connect the
phone cord.
The following are usually analog phone lines:
• Fax lines
• Lines used by modems or credit card readers
• Residential phone lines
A phone line splitter is supplied if you want to tap
into the fax line.
Phone
Step 1 - Unpack Box Contents
WARNING! Do not apply power until Step 4.
Most phone systems installed in businesses are not analog and
may damage your DM200L. If you are unsure about your phone line,
contact your telephone company or local network administrator.
Step 3 - Connect Power
Plug the power cord into a convenient outlet.
Power