ProForm PFSB62830 - Manual (Page 17)

17
10. SYMPTOM: THE SPA JET UNIT CONTINUES
TO RUN AFTER IT HAS BEEN SHUT OFF
a. The spa jets are controlled with the jet button. If
the button is pressed once, the spa jets will run
at low speed. If the button is pressed again, the
spa jets will run at high speed. If the button is
pressed a third time, the jets will shut off. Note:
If the actual temperature of the water in the spa
is below the set temperature, or if the spa is
running a filter cycle, the heater pump/motor
will not shut off.
11. SYMPTOM: NO AIR FLOWS THROUGH THE
ADJUSTABLE HYDROTHERAPY JETS WHEN
THE AIR CONTROL IS TURNED COUNTER-
CLOCKWISE
a. If no air flows through the hydrotherapy jets when
the air control is turned counterclockwise, simply
turn the rims of the jets counterclockwise.
Turning the rims clockwise will close the jets.
12. SYMPTOM: THE CONSOLE DISPLAYS THE
WORDS “COOL” OR “ICE”
a. This is a normal function of the spa; no action
is necessary. The word “COOL” will appear in
the display if the temperature of the water is
more than 20°F cooler than the set temperature.
If this happens, the heater will automatically
activate to warm the water. The word “ICE” will
appear if the temperature drops below 40°F. If
this happens, the pump will automatically circu-
late the water and warm the plumbing.
13. SYMPTOM: THE CONSOLE DISPLAYS ONE OF
THE FOLLOWING MESSAGES: “OH,” “5n1,”
“5n3,” “FLO,” “Pd,” “O3,” “PH50,” “PH90,” or
“ILOC”
a. If the console displays one of the messages
listed above, or if the console does not function
properly, contact our customer service depart-
ment.