Planar Dome EX - Manual (Page 42)

32 | Dome EX Display
-s Silent mode. Use a response file instead
of prompting user response during
installation.
-f1<path\response file> Use the response file specified during
installation. If no -f1 switch is given, the
installation uses the response file in the
same directory in which setup.exe
resides.
-f2<path\log file> Save any output to the log file specified
during installation. If no -f2 switch is
given, the installation saves to the log
file in the same directory in which the
response file resides. This may cause
a problem if setup is run from the CD-
ROM drive.
-remove Run uninstallation.
-bit8 Set all Dome CX or Dome EX displays to
8-bit mode (default).
-bit32 Set all Dome CX or Dome EX displays to
32-bit mode. Grayscale switches are
ignored when this switch is specified.
-static Set 8-bit mode to static gray palette
(default).
-notstatic Set 8-bit mode to dynamic gray palette.
-yesddraw Enable DirectDraw (default).
-noddraw Disable DirectDraw.
-autodetect Enable AutoOrientation for Dome EX
displays (default).
-noautodetect Set all displays to portrait orientation.