Plus Corporation BOARD FAX BF-035 - Manual (Page 10)

6
As illustrated, set the new roll in
so that the tip of thermal paper
extends about 20cm (8") from the
outlet.
● When a red line appears at the edges of the recording paper. The red line will
appear when there is only about one meter (3 feet) or so of recording paper left on
the roll.
● When the paper out lamp lights red.
HOW TO USE
Note:
● Please use only the correct type of recording paper.
● Particular attention must be given to the winding direction of the recording paper, since
copying cannot be performed if the winding direction of the recording paper is reversed.
● Be sure to keep the recording paper straight when loading, failure to do so may cause
wrinkling or tearing of the paper during the copy function.
To close the cover, push both ends
of it until it locks with a clicking noise.
At this time, make sure that the
thermal paper has not slipped off the
edge.
Replace the recording paper in the following situations
Cut off the extra thermal paper
from the printer outlet.
*Automatic Power Cut-off Function
If there is no key operation for about an hour, the fluorescent lamp inside the unit automatically
shuts off and the machine enters a state of power conservation. (At this time, the power indicator
remains lit.)
Once a key is pressed, the fluorescent lamp will light again, and the normal operating condition
is restored.