Printek FormsPro 4300 - Manual (Page 102)

Setup Menu Summaries
J-2
Setup: INTERFACE _________________
_ (Two Beeps)
_
___
Mode: Test, ANSI X3.64, Epson*, Bar Codes, Proprinter,
_
LA-120, TTY, Printek, Barberpole, or Hex Dump
___
I/O: Parallel*, Serial, or CX/TX †
___
Baud Rate: 150, 300, 600, 1200, 2400, 4800, 9600*, or 19200 †
___
Data Bits: 7 or 8*
___
Parity: None*, Ignore, Odd, or Even †
___
Busy: Low* or High †
___
DTR: Power*, Online, or Busy †
___
XON/XOFF: Off* or On †
___
ETX/ACK: Off* or On †
___
Auto CR: Off* or On
___
Auto LF: Off* or On
___
Long Line: Wrap* or Trunc
___
Left Edge: Fixed or Float*
___
FF at TOF: Yes* or No
___
Scroll Delay: 1* or 0 through 15
___
Fault: Break Pg*, or Reprint Pg
___
Page Size: 256* or 512 through 28160 †
___
Chars: Control* or Printable
Setup: OPTIONS ______________
_ (Three Beeps)
_
___
Max Form #: 0 through 9
___
Ribbon Check: On*, Off
___
Ribbon Life: 23*, or 5 through 30
___
Paper Cutter: Yes or No*
___
Imager: Yes or No*
___
Translation: Off* or On †
___
Free Format: Off* or On †
___
Terminator: LF* or CR †
___
Ignore Char: Off* or On †
___
Zero: Normal or Slashed* †
___
Ignore Col 1: Yes or No* †
___
Control Char: ^*, ~, !, ?, ;, ', |, or \ †
___
Bar Codes: Lo-Res, Med-Res, Hi-Res* †
Setup: SECURITY _______________
_ (Four Beeps)
_
___
Forms: Edit*, View, or Init
___
Interface: Edit*, View, or Init
___
Options: Edit*, View, or Init
___
Clone: Off*, Transmit, Receive
* Indicates the factory default setting.
† Indicates a menu function and/or value which may not be available unless the appropriate option is
installed, or selected, in the printer.