PHL Audio B46 - Manual (Page 2)

Ø 457 max.
Ø 422 max.
Ø
476 max.
(on angles)
+ Red dot
15
172 max.
2 x screw button terminals
8 x Ø 7 Holes eq. spaced on Ш 454
Ш 225 max.
7010 7090
TYPICAL CHARACTERISTICS
Rated impedance Z 8 8 Ω
Reference efficiency (1 W@1 m) - 98 98 dB SPL
Usable frequency range 1 - 30-800 30–800 Hz
Power handling capacity 2 (AES) - 1000 1000 W
Max Sound Pressure Level
3
SPLmax 124 124 dB SPL
Min. impedance modulus Zmin 6.8 @ 200Hz 6.8 @ 200Hz Ω
Voice-coil inductance 4 @ 1 kHz Le1k 1.80 1.80 mH
@ 10 kHz Le10k 0.87 0.87 mH
Bl product Bl 26.6 26.6 N/A
Moving mass Mms 0.180 0.191 Kg
THIELE-SMALL PARAMETERS : TYPICAL (QC LIMITS)
Resonance frequency 5 Fs 35 (±5) 34 (±5) Hz
DC resistance 6 Re 5.6 (±0.5) 5.6 (±0.5) Ω
Mechanical quality factor Qms 4.0 4.1 1
Electrical quality factor Qes 0.31 0.32 1
Total quality factor Qts 0.29 0.30 1
Mechanical suspension compliance Cms 115 115 10 -6 m/N
Effective piston area Sd 0.128 0.128 m 2
Equivalent Cas air load Vas 0.260 0.260 m 3
Max. linear excursion Xmax 8.0 8.0 mm
Linear displacement volume Vd 1.024 1.024 10 -3 m 3
Half-space efficiency 3.5 3.1 %
Unity load volume Vas Qts 2 22.3 23.6 10 -3 m 3
ABSOLUTE MAXIMUM RATINGS
Short term max. input voltage 7 Vmax 180 180 V
Max. excursion before damage Xdam 16 16 mm
Ambient operating temperature –10 to +50 °C
Storage temperature 8 –20 to +70 °C
Environmental conditions 9 Outdoor Outdoor ✚
APPLICATION INFORMATION
Air volume occupied by the driver 10 6.9 6.9 10 -3 m 3
Speaker net mass 10.9 10.9 Kg
Recommended reflex box Vb/Fb 150 / 38 L / Hz
Electrical polarity A positive voltage applied on the red
terminal produces forward cone motion.
PHYSICAL CHARACTERISTICS
PHL Audio S.A. provides these specifications as representative of current production after conditioning. Because of our continuous research, they are subject to change without notice.
SPECIFICATION NOTES
Note 1 : Allowing for energy response, excursion
capability, Power spectrum, and -3dB low
freq. roll-off for standard reflex tuning.
Note 2 : Established at 20°C ambient temp, according to
AES2-1984 standard using IEC268-1 simulated
programme signal and a 150 liter Bass-Reflex test
enclosure tuned at 40Hz.
Note 3 : Established at 1m on axis of the loudspeaker mounted
in test enclosure, when driven at full AES Power
Handling Capacity, including 4dB of thermal
compression loss.
Note 4 : Measured at 20 mA in free air.
Note 5 : Measured at 20 mA and 20°C ambient temp.
in free air conditions, after full run and rest.
Note 6 : Measured at 20°C ambient temp.
QC limits are ±10%
Note 7 : Stated in RMS voltage according to IEC 268-5.
Note 8 : Includes shipping conditions. The lower limit prevents
from demagnetization.
Note 9: Our products are classified in three categories :
Indoor, Outdoor, and Outdoor ✚ for permanent
outdoor use or severe conditions.
Note 10 : Calculated for front mounting on to a 18 mm thick
board.
461, rue des chênes
■
Z.A
7 7 5 9 0 C H A R T R E T T E S
FRANCE
T é l : 33 01 64 81 29 80
Fax : 33 01 60 69 10 28
e-mail : [email protected]
http: //www.phlaudio.com
7010
■
7090
18” Bass Extended Drivers