Princess PI 1010A - Manual (Page 18)

DATE PRINTED: 2/8/05 Revision Date: 02/01/05 PI-1010A Page 18
Assembly Instructions for Princess PI1010A Insert
There will be local building and fire codes which could affect this installation. Be sure you check with your local
building inspector, fire inspector or other local authorities having jurisdiction in your area before you begin instal-
lation. This insert is certified only for installation into a masonry fireplace or factory built fireplace listed to UL 127
or ULC S620 which have been carefully inspected and are in good condition.
Blaze King recommends that you use a qualified Blaze King installer to assemble and properly install your
PI1010 insert. Technicians are certified by the HPBA in the USA and by WETT in Canada.
Provide protection for the hearth to prevent damage while sliding the heavy insert in and out of the fireplace
opening.
1) Carefully remove and inspect the insert parts from the shipping packages. The parts should include the
fireplace insert, (see Fig. 1) 2 shroud side panels, 1 shroud top panel, 1 shroud outer trim package,
1 shroud convection deck, 2 #6-32 brass screws .
2)
Place the fireplace insert on the work area , the unit is shipped without any shroud parts in place. Attach
the two-shroud side panels to the unit by loosening the screws on the covers on either side of the unit and
slide the shroud sides between the covers and the unit and retighten the screws ( see Fig. 2 ) .
Figure 1
Assembly - General
Figure 3
Figure 2