Panasonic AG 527DVDE - Manual (Page 31)

31
Timer Operation
Repeat steps 1 and 2 on page 30.
1
Press PROG twice to exit this mode.
2
3 To Replace program...
To Clear program...
4
Press to select
the desired program.
1) Press SET to display.
2) Press
to select
and press SET or
to set new
program contents.
3) Press PROG.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
Press ADD/DLT.
Review, Replace or Clear Program
Contents : (Recording is not in progress)
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC” appears
and/or the PROG TIMER Indicator flashes.
Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up
during a normal recording or One Touch Recording
(page 18), the Timer Recording will not be performed.
• If there is a power interruption of more than one
minute, the recording may not be performed or
continued.
• If “INCOMPLETE” appears after all items have been
set, check all entries and make necessary
corrections.
Notes
*Important: I
f a remote control button does not work when pressed, press the button on the remote
and try the button again.
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER : SET
END : PROG
8 SAT 9:00P 12: 00A 08
DATE START STOP CH
SELECT :
SET : SET
END : PROG
BACK :
SELE CT START DATE
TODAY
SLP
- - - - - - - - -- - - - - - - -- - - - - - -
P DT START STOP CH SPD
1 -- -- : -- -- : -- -- --
2 8 10 : 00p 12 : 00a 125 SP
3 10 8 : 00p 9 : 00p 10 SP
4 SU 9 : 00p 10 : 00p L LP
SELECT 1 - 8 :
ENTER : SET
END : PROG