PC Concepts 500PS - Manual (Page 133)

The Front Panel Menu Structure Navigating the Menu System Message Descriptions

Media & Ink Introduction Front Panel Other
Printer
Options
Index Solutions
Option not available now You have selected an option in the menu that is not available at the
moment. (The printer may be busy, out of ink, out of paper, etc.)
Out of paper The printer ran out of paper while printing the calibration pattern.
Load a sheet or roll that is at least 65 cm (25 inches) long and 50 cm
(20 inches) wide.
Paper advance calibration is
recommended.
Press ENTER to calibrate You are recommended to perform the Advance calibration routine, to
ensure the optimum print quality.
Press the Enter key to create the calibration pattern. See
Advance
Calibration .
Paper advance calibration is
recommended. Load paper
and select Paper advance
calibration.
Press ENTER to finish You are recommended to perform the Advance calibration routine, to
ensure the optimum print quality.
Load a sheet or roll of paper and then select Advance calibration
from the Paper menu. See
Advance Calibration .
Paper loaded with too much
skew
Press ENTER to retry
Press CANCEL to abort During the loading of paper, the printer has detected that the paper
is skewed too much, that is, it has not been loaded straight enough.
(‘Skew’ is the angle between the actual paper edge and the correct
line.)
Either: Press the Enter key to restart the loading procedure;
Or: Press the Cancel key to cancel paper loading.
Front Panel Messages (continued)
Message Explanation and Action
For more Messages, click on the Next Page button