PYLE Audio PAD10MXU - Manual (Page 2)

(1)
PAC10MXU
[]] ! �:�R
L.IN� 213
MAIN OUT
MONITOR
[ill
..
IIt�
, POWER
0
, " " "
(ldB OdB "'10c1e
FRONT PANEL
I. CH I-COMBO INPUT CONNECTOR OFFERS BOTH FEMALE XLRAND?" PHONE JACK FOR
MICILINE INPUTS
2. LINE 213 STEREO LINE INPUTS RCA PLUGS, LET YOU CONNECT CD, MP3, TAPE DECK, PLAYERS.
3. MAIN OUT RCA PLUGS TO CONNECT THE MIXER TO A RECEIVER ORAMPLIFIER
4. MONITOR THIS IS USED TO MONITORING THE MASTER SIGNAL OUTPUT THRU
THE HEADPHONES
5. LINE! MIC SW INPUT SELECT SWITCH, SET THIS SWITCH BASED ON WHAT IS PLUGGED
INTO CH I
6. LINE 213 LEVEL CONTROL THIS CONTROLADJUST THE VOLUME OF SIGNAL INPUT OF
LINE 213
7. PEAK L,E,D. IT LIGHTS UP WENT THE INPUT SIGNAL OF CH 1 IS TO HIGH
8. CH I GAIN CONTROL THIS CONTROL ADJUST THE VOLUME OF SIGNAL INPUT OF CH 1
9. PHANTOM POWER THIS SWITCH ACTIVATES THE PHANTOM POWER SUPPLY ON THE
XLR CONNECTOR OF CH 1
10. PHANTOML.E.D. INDICATES THAT PHANTOM POWER IS ON
II. USBILINE INPUT SELECT SWITCH SET THIS SWITCH TO ACTIVATE THE USB DATA
CONNECTOR FROM YOU COMPUTER OR YOU LINE INPUT
12. MASTER CONTROL LETS YOU CONTROL MIXER' S OVERALL VOLUME LEVEL SEND TO
THE MAIN OUT
13. CLIP L.E.D. LIGHTS UP WHEN THE MAIN OUT PUT SIGNAL IS TOO HIGH
14. MONITOR CONTROL TO CONTROL VOLUME OUTPUT OF THE MONITOR JACK
15. POWER L.E.D. INDICATES THAT THE UNIT IS IN ON POSITION
REAR PANEL
DC IN 5V SOOmA
Uad8In Cl'lllna
(2)