Pentax PocketJet 3 - Manual (Page 29)

END OF PAGE
Clean:
Clicking on this button places the printer in “Cleaning Mode”.
Refer to that maintenance procedure in this manual for further
instructions.
Upload Font:
Clicking on this button will guide you through the process of
uploading new fonts to the printer.
Upgrade Firmware:
Clicking on this button will guide you through the process of
uploading new firmware to your printer. See Program Mode,
page 5, for further information.
Factory Reset:
Clicking on this button will return the printer to its original
factory settings for fonts and configuration. The configuration
data from the file \PJ3Factory.cfg will be loaded and
displayed. Since that file is expected to match the internal
factory configuration of your printer, this file’s properties are
set to “Read Only” and it should not be modified.
Save Config:
Clicking on this button will save the configuration as you see it
to the file \PJ3Default.cfg and then send this configuration
information to the printer. Be sure that all of the settings are
adjusted to your liking.
Close:
Closes this application without sending data to the printer and
without saving the current settings.
Page 21