Panasonic 15000 User Manual
Page 132
- 132 -
List of terms
Nortel Multiservice Switch 7400/15000/20000
Terminology
NN10600-005 7.2S1 Standard
PCR7.2 and up March 2006
Copyright © 2006, Nortel
Nortel Confidential
T4
Timing towards a 2 MHz (or 2 Mbit/s, no payload) synchronization interface.
tag control information (TCI)
Tag control information (TCI) is a subheader of the IEEE 802.1Q tag header.
It consists of two octets encoded with user-priority bits, a canonical format
indicator field, and a VLAN identifier.
tag protocol identifier (TPID)
Tag protocol identifier (TPID) is a subheader of the IEEE 802.1Q tag header.
It consists of two octets encoded with the 802.1Q tag type for VLANs. The
format of the encoding is dependent on the type of encoding supported: SNAP
or Ethernet.
tandem node
A node between the ingress and egress nodes that decides independently the
best packet forwarding route to the egress node identified in the packet. See
tandem pass through (TPT)
A software process that allows MVP-E FPs on tandem Nortel Multiservice
Switch nodes to dynamically detect each other and pass, without modification,
compressed voice data through an intermediate voice switch. Voice Transport
and Voice Networking support TPT.
TC
See
trunk conditioning (TC) (page 137)
TCI
See
tag control information (TCI) (page 132)
.
TCP
See
transmission control protocol (TCP) (page 136)
TDM
See
time-division multiplexing (TDM) (page 133)
.
TDMA
See
time-division multiple access (page 133)
.
TDP
See
traffic descriptor parameter (TDP) (page 135)
.
TDS
See