Parkside PPHSS 730 SE - Manual (Page 11)

10 GB/IE/CY
½
Use only undamaged, defect-free saw blades.
Distorted or blunt saw blades can break or
cause a kickback.
½
Always keep the device clean, dry and free of
oil or grease.
© Original accessories /
attachments
½
Use only the accessories and attachments de-
tailed in the operating instructions. The use of
inserted tools or accessories other than those
recommended in the operating instructions
could lead to you suffering an injury.
© Preparing for use
© Information about saw blades
The Parkside equipment supplied as standard with
your tool includes saw blades intended mainly for
sawing wood and metal.
1 blade (wood) for quick cutting
in softwood (green arrow marking)
1 blade (wood) for clean
cutting in softwood (orange arrow marking)
1 blade (special) for metal up to 3 mm thick
(black arrow marking)
Note: Use a suitable coolant, e.g. cutting oil. This
improves the endurance and increases the service
life of the metal saw blade.
Saw blades are available which have been opti-
mally designed for particular tasks. You can use
any of these saw blades provided they have the
correct shank fitting (single lug shank).
© Mounting / replacing
saw blades
Saw blade type
Suitable for
PPHSS 730 SE Unsuitable
WARNING! Pull the mains plug out of the
socket before you carry out any task on the
device, otherwise there may be risk of injury.
˽
Turn the quick-release chuck 18 and hold it in
the turned position.
˽
Press the selected saw blade 14 up to the stop
in the quick-release chuck 18 .
The saw blade 14 should then engage.
˽
The saw blade 14 must lie in the guide roller 13 .
˽
Release the quick-release chuck 18 . The chuck
must then return to its original position.
The saw blade
14 is then locked in place.
© Attaching the chip guard
˽
Pull the runner 10 off the base plate 9 .
˽
Insert the chip guard 16 from below into the
base plate 9 and slide it into the slots provid-
ed. The chip guard can help prevent breaking
out of the surface.
General safety advice for electrical power tools / Preparing for use