Pioneer VSA-AX10Ai User Manual
Page 23
23
Cannot send measurement data to PC
Cause 1:
Random transmission errors sometimes occur.
Even if an error occurred on your first attempt, try sending the data again. Sometimes the transmission
succeeds when you try again.
Cause 2:
Messages like the following may appear if a transmission error occurs.
Try the following, in the order indicated.
1) Reselect the number of the COM port.
2) In the setup screen of the amplifier, check that “Operate a PC” is displayed. (This message indicates
that the amplifier is ready to send data to the PC.)
3) Exit any other active applications.
4) Restart the Advanced MCACC application.
5) Restart your PC.
6) Check that the RS-232C cable is properly connected. (Be sure to switch off all components and
disconnect their power cord from the power outlets before changing any cable connections.)
Note that the measurement data in the amplifier’s memory to be sent to the PC will be lost when the power is
switched off. You will need to do another measurement.
Troubleshooting (Continued)
Continue
Continue