PYLE Audio PICDLD82I - Manual (Page 7)

E-13 E-14
WHEN ELECTROSTATIC DISCHARGE (ESD) OCCURS AT THE FRONT SURFACE
(WHETHER METAL OR PLASTIC) OR NEAR ANY PART OR ANY BUTTON OF THIS
UNIT, OR AT THE USB PORT AND/ OR SD-CARD SLOTS (IF THEY EXIST ON THIS
PRODUCT), THERE MAY BE A POSSIBILITY THAT THE PRODUCT MAY STOP
OPERATION AND/ OR SHUT DOWN IMMEDIATELY. THIS IS A NORMAL CONDITION
AND INTENDED TO PROTECT THE UNIT AND INTERNAL COMPONENTS AGAINST
DAMAGE.
IN SUCH A CASE, PLEASE RESET THE UNIT (BY DISCONNECTING AND
RECONNECTING AC-POWER SOURCE) TO REVERT THE UNIT TO NORMAL
OPERATION.
ELECTROSTATIC DISCHARGE (ESD) PRECAUTION
BATTERY SHOULD NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE,
FIRE OR THE LIKE.
THE APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHING AND
NO OBJECTS FILLED WITH LIQUIDS SHOULD BE PLACED ON THE APPARATUS.
THE MARKING AND RATING LABEL IS LOCATED AT REAR/ BOTTOM ENCLOSURE
OF THE APPARATUS.
THE MAINS PLUG IS USED AS THE DISCONNECT DEVICE AND IT SHALL REMAIN
READILY OPERABLE. TO BE COMPLETELY DISCONNECTED THE POWER INPUT,
THE MAINS PLUG OF THE APPARATUS SHALL BE DISCONNECTED FROM
THE MAINS COMPLETELY. THE MAINS PLUG SHOULD NOT BE OBSTRUCTED
OR SHOULD BE EASILY ACCESSED DURING INTENDED USE.
UNDER THE INFLUENCE OF ELECTROSTATIC PHENOMENON,
THE PRODUCT MAY MALFUNCTION AND USER TO POWER RESET.
EXCESSIVE SOUND PRESSURE FROM EARPHONES AND HEADPHONES CAN
CAUSE HEARING LOSS.
CAUTION
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE.
II) DC JACK - 2
THIS JACK IS DESIGNATED FOR USE WITH THE SUPPLIED UNIVERSAL ADAPTER WIRE,
IN COMBINATION WITH ONE OF THE SUPPLIED CONNECTORS, TO CHARGE ONE OF
SEVERAL MOBILE PHONES.
LIFT THE UNIT TRAY, CONNECT THE TAIL END OF UNIVERSAL ADAPTER WIRE INTO THE
DC JACK-2, AND CONNECT ONE OF THE SUPPLIED ADAPTER CONNECTORS TO THE
UNIVERSAL ADAPTER WIRE FEMALE SOCKET.
INSERT THE ADAPTER CONNECTOR TO THE RESPECTIVE MOBILE PHONE’S ADAPTER
SOCKET, WHICH NEEDS TO BE CHARGED.
THE UNIT SHALL THEN AUTOMATICALLY BEGIN CHARGING THE RESPECTIVE MOBILE
PHONE.
*NOTE: AT ANY GIVEN TIME, ONLY ONE OF THE DC-JACKS CAN BE USED.
IN THE EVENT THAT THE SUPPLIED WIRES AND CONNECTORS ARE UNABLE TO CHARGE
YOUR MOBILE PHONE, THIS UNIT IS EQUIPPED WITH A USB (CHARGING ONLY) JACK TO
CHARGE MOBILE PHONES THAT ARE SUPPLIED WITH USB CABLES.
THE USB JACK ALLOWS FOR NOT ONLY CHARGING OF MOBILE PHONES BUT ALSO
HUNDREDS OF OTHER DEVICES, COVERING BLUETOOTH HEADSETS, PORTABLE GAME
CONSOLES AND MANY MORE. TO USE THE USB JACK CHARGING CAPABILITY:
LIFT THE UNIT TRAY, CONNECT THE TAIL END OF THE USB-WIRE (SUPPLIED WITH YOUR
MOBILE PHONE OR THIRD PARTY DEVICE) INTO THE DC JACK, AND CONNECT THE
DEVICE ADAPTER END ON THE USB-WIRE INTO THE RESPECTIVE SOCKET ON THE
DEVICE IN NEED OF CHARGING.
THE UNIT SHALL THEN AUTOMATICALLY BEGIN CHARGING THE RESPECTIVE DEVICE.
CHARGING 3: USB JACK
2 1
WIRE CONNECTOR
MINI USB
MICRO USB
SAMSUNG
MOTOROLA
SONY ERICSSON
(Male3.5x1.1mm) (Female3.5x1.1mm)
DEVICES CONNECTOR
(Male3.5x1.1mm)
THIS UNIT COMES WITH 5 CONNECTOR ADAPTERS, TO COVER CHARGING OF MOST
POPULAR MOBILE PHONE MODELS AND BRANDS, DETAILS AS ABOVE DRAWING.
CONNECTOR COMPATIBILITY
(MOST BLACKBERRY
& HTC UNITS)
(SELECT BLACKBERRY
& OTHER UNITS)
SPECIFICATIONS
POWER SUPPLY : ............... DC 6V, 3A THOUGH BUILT-IN DC JACK
EXTERNAL AC-DC POWER ADAPTOR 110V-240V ~ 50/60Hz
SPEAKER : ........................... MAIN SPEAKER 2" x 2
FREQUENCY : ..................... FM 87.5 - 1 08 MHz
USING THE AUDIO LINE IN CONNECTION (AUX-INPUT)
- YOU CAN CONNECT THE AUDIO OUTPUT OF AN EXTERNAL DEVICE SUCH AS A MP3
PLAYER TO THIS UNIT, TO LISTEN TO THE SOUND OF THAT DEVICE THROUGH THE
HIGH QUALITY AMPLIFIER OF THIS MUSIC SYSTEM.
- TO CONNECT THE EXTERNAL DEVICE PLEASE USE A STANDARD STEREO
HEADPHONE (3.5MM TO 3.5MM PLUGS) CABLE TO CONNECT THE
"HEADPHONE-OUT OR AUDIO LINE-OUT" OF THE DEVICE TO THE AUX-INPUT SOCKET
OF THIS UNIT.
- SWITCH THE FUNCTION TO "AUX" USING THE FUNCTION KEY ON UNIT OR AUX KEY
ON REMOTE CONTROL.
- SWITCH ON THE UNIT AND THE EXTERNAL DEVICE (eg. MP3-PLAYER).
- START PLAYBACK OF THE EXTERNAL DEVICE AND ADJUST THE VOLUME CONTROL
OF THE MAIN UNIT TO THE DESIRED LEVEL.
- REMEMBER TO SWITCH OFF THE UNIT WHEN YOU ARE FINISHED USING THE
EXTERNAL DEVICE.