Panasonic TC 32LH1 - Manual (Page 31)

31
Operating peripheral equipment using the remote control
The Universal Remote Control can be programmed to operate many manufacturers’ components, using the
component function buttons for VCR, DVD, AUX, RCVR, TV, DTV, CABLE or DBS. Follow the procedures
for programming your Remote Control with or without a code for the component.
Determine the manufacturer of the component and look in the table for the code.
Programming The Illuminated Remote Control Using Access Codes
1
Confirm that the external component is plugged in and operating.
2
Turn the component off.
3
4
5
Enter the 3-digit component code using the Remote Control numeric
keypad.
Press POWER and OK together, for at least 5 seconds.
After 5 seconds, all the illuminated mode keys will begin to flash.
Release the POWER and OK keys. POWER +
1 2 3
4 5 6
7 8
0
9
POWER
CH
CH
VOL VOL
O K
DTV
AUX
DVD
VCR
DBS
RCVR
CBL
TV
Press the mode key.
The mode key will illuminate steadily, all others will go out.
Press the Remote Control POWER to test the component. If the
procedure is successful, the component will turn on.
Device
TV
DTV
CABLE
DBS
VCR
DVD/CD
AUX
RCVR
Operates
TV (Panasonic Only)
DTV (Panasonic Only)
CABLE (Preset)
DBS (Preset)
VCR (Preset)
DVD and CD (Preset)
Personal Video Recorders,
Tape and VCR2
Audio Receiver (Preset)
Default
Panasonic TV Codes
Panasonic DTV Codes
Panasonic CABLE Codes
Panasonic DBS Codes
Panasonic VCR Codes
Panasonic DVD Codes
Panasonic Personal Video
Recorders Code
Panasonic RCVR Code
Default Modes For Remote Control
6
If the component does not operate with the Remote Control, repeat the
procedure using another code. (Some brands have multiple codes).
If an incorrect code is entered, or if the procedure takes longer than 30
seconds,the programming will fail.
Helpful Hints: Unsuccessful Code