Procom ML060HPA - Manual (Page 7)

7
INSTALLATION
Figure 4 -Mounting clearances As
Viewed From Front of Heater
WARNING: Maintain the
minimum clearances shown
i n F i g u r e 4 . I f y o u c a n ,
provide greater clearances from
floor, ceiling, and joining wall.
Figure 7 - Mounting Bracket
Clearances
Figure 6 - Removing Lower Front
Panel Of Heater
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket is located
on back panel of heater (see
Figure 5). It has been taped there
f o r s h i p p i n g . r e m o v e m o u n t i n g
bracket from back panel.
Removing Lower Front Panel Of
Heater
1. Remove two Screws near
bottom corners of lower front
panel.
2. Pull bottom of lower front panel
forward, then down (see Figure
6).
Methods For Attaching Mounting
Bracket To Wall
Only use last hole on each end
of mounting bracket to attach
bracket to wall. Attach mounting
bracket to wall only in one of two
ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud: This method
provides the strongest hold. Insert
mounting screws through mounting
bracket and into wall studs.
Attaching to Wall Anchor: This
method allows you to attach
mounting bracket to hollow walls
(wall areas between studs) or to
solid walls (concrete or masonry).
Decide which method better
suits your needs. Either method
will provide a secure hold for the
mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall
where heater will be located. Make
s u r e m o u n t i n g b r a c k e t i s
level.
2. Mark screw locations on
wall. (see Figure 7)
Note: Only mark last hole on
each end of mounting bracket. In-
sert mounting screws through
these holes only.
3. Remove tape and mounting
bracket from wall.
WARNING: Maintain mini-
mum clearances shown in Fig-
ure 8. If you can, provide greater
c l e a r a n c e s f r o m f l o o r
and joining wall.
Figure 5 -Mounting Bracket
Location