Polaris 340 - Manual (Page 11)

www.polarispool.com
Action: Polaris is not moving.
Solution: 1. Remove bottom plate and
verify that the intake area is
free of debris.
2. Remove top housing and
make sure propeller is free
of debris.
3. Check for proper water flow.
If low:
a. Clean the pool filter and
pump basket.
b. Verify that the skimmer or
dedicated suction line
connection is secure.
c. Adjust the flow regulator or
the suction line valve in the
equipment area. Recheck the
wheel RPM once you have
obtained proper flow.
4. Remove lower housing to
ensure that belts are on and
properly tensioned.
Troubleshooting Worksheet
If these solutions do not result in
improved performance, contact the
Polaris dealer who sold you the cleaner
or call Customer Service.
In order to provide faster and more
convenient service, please have the
following information available at the
time of your call or when taking the
Polaris in for service.
1. Serial #:________________________
2. Wheel RPM:__________________
3. Is the Polaris cycling properly?
(The wheels should turn backwards
approximately every 1-1/2 minutes.)
Yes No
4. Is the feed hose the proper
length?
Yes No
How many hose sections are used? ________
How many hose sections extend past the end
of the pool? ______
5. Is the swivel rotating freely?
Yes No
6. What is the pool filter pressure?
Now? ___________________psi
Just after cleaning? ________psi
When was the pool filter last cleaned?
1-2 months ago
3-5 months ago
Over 6 months ago
English