Panasonic WJ-HD316 - Manual (Page 16)

16
z
Insert the power plug to an outlet (AC 120 V,
60 Hz)
Note: Make sure the power source is AC 120 V, 60 Hz.
x
Turn on the power switch on the rear panel.
The OPERATE indicator will light and the system check
(checking the system and hard disk) will start.
The startup splash image below will be displayed on moni-
tor 2 and the VGA monitor during the system check.
When the auto login is off, the login window will be dis-
played if any button on the front panel of this unit is pressed
after the system check. (Go to step 3)
When the auto login is on, live images will be displayed
after the system check.
Notes:
• If the hard disk configuration had been changed after
the last startup or the hard disk has problems, the HDD
DISK MENU will be displayed automatically after the
startup splash. (Refer to page 127 for further informa-
tion.)
• It is possible to display the disk configuration menu by
pressing the SET button when the image below that
says the system check has been completed is dis-
played.
Important:
When using the optional extension unit (WJ-HDE300),
turn the power of this unit after turning on the power of
all extension units.
c
Enter a user name and password.
Rotate the jog dial to select a character to be entered in the
cursor position.
It is also possible to enter numbers by pressing the camera
selection buttons ([1] - [10/0] for the WJ-HD316, [1] - [9],
[0] for the WJ-HD309).
To move the cursor, press the arrow buttons.
Use the same method to enter or edit characters attached
to images. Refer to page 54 for further information.
v
Display a live image.
Press the SET button to display a live image.
If the authentication window is displayed, enter user name
and password.
When authenticated, a live image will be displayed.
When not authenticated, the authentication window will be
displayed again.
STARTUP