Panasonic CT-2701 - Manual (Page 11)

11
ENGLISH
VHF 2-13
UHF 14-69
CATV 1-125
75 Ohm (VHF/UHF/CATV) Coaxial Input
1.0 Vp-p/75 ohms
0.3 Vp-p/75 ohms
In(RCA) 1.0 Vp-p/75 ohms
Out(RCA) 1.0 Vp-p/75 ohms
In(RCA)-8 dBm/50 K ohms
Out(RCA)-8 dBm/1 K ohms
VHF/UHF IN 75 ohms coaxial
25-9/16" (W) x 19-11/16" (D) x 22-1/2" (H)
80.5 Ibs
Receiving Channels:
Antenna Input Impedance:
Inputs/Outputs: S-Video: Y-Input:
C-Input:
Video:
Audio:
Antenna:
Dimensions:
Weight:
TROUBLESHOOTING GUIDE
Before requesting service, please refer to the following chart for the symptom and possible solution.
Remote Control
Batteries (AA) x 2
ACCESSORIES
SPECIFICATIONS
AC Power Input:
AC Power Consumption:
Chassis Construction:
Picture Tube:
Horizontal resolution:
Audio Power Output Rating:
Speaker:
Tuner Type:
Remote Control:
120V, 60Hz
125 Watts
IC Solid state
27" (measured diagonally)
260 lines
1.5 + 1.5 Watts
2" x 3-1/2" Full Range, 8 ohms x 2
181 Channel, Quartz PLL Frequency
Synthesized
Infrared, Direct Access, 2 x AA batteries
(supplied)
SYMPTOMS POSSIBLE SOLUTIONS
• Make sure the power cord is plugged in.
• Try another AC outlet.
• Power is off, check fuse or circuit breaker.
• Unplug unit for an hour, then plug it back in.
• Station or CATV experiencing problems, tune to another station.
• Make sure channels are set into memory.
• Check antenna or CATV connections, adjust antenna.
• Check for sources of possible interference.
• Check picture control adjustments.
• Station or CATV experiencing problems, tune to another station.
• Make sure channels are set into memory.
• Station is weak, adjust antenna to receive desired station.
• Check for sources of possible interference.
• Station or CATV experiencing problems, tune to another station.
• Make sure channels are set into memory.
• Check picture control adjustments.
• Check antenna or CATV connections, adjust antenna.
• Check for sources of possible interference.
• Station or CATV experiencing problems, tune to another station.
• Make sure channels are set into memory.
• CATV company is scrambling signal.
• Adjust antenna.
• Check all CATV connections.
• Set TV/CATV menu option to the CATV mode.
• Station or CATV system problems, try another station.
• Check antenna connections, adjust or re-direct antenna.
• Check for sources of possible interference.
TV does not operate
Poor sound or No sound
Poor picture or No picture
Horizontal or diagonal bars on screen
• Select proper language in the SET UP mode. Display is not shown in your language
No reception above channel 13
No CATV reception
Picture wobbles or drifts
Poor reception on some channels
• Batteries are weak, dead or inserted incorrectly.
• Remote is out of range, move closer to TV (within 15 feet).
• Make sure Remote is aimed at sensor.
• Confirm there are no obstructions between the Remote and the TV.
• Make sure the power cord is plugged in.
• Make sure TV/CATV menu option is in the appropriate mode.
• If using antenna, check UHF antenna connections.
• No broadcast on station tuned.
• Timer is set.
• Power interrupted.
• TV station experiencing problems or program tuned is not closed
captioned. Try another channel.
• Check CATV connection or VHF/UHF antenna, reposition or rotate
antenna.
• Select the Closed caption.
Cannot see closed caption
No Remote operation
TV shuts off
Poor color or no color
• Station or CATV experiencing problems, tune to another station.
• Check sound adjustments (VOLUME and MUTE).
• Check for sources of possible interference.
3N42201A E P09-P13 6:7:03, 00:46 11