Pioneer PDP-S09LR - Manual (Page 5)

5
English
English
SPECIFICATIONS
NOTE:
Specifications and design subject to possible modification
without notice, due to improvements.
Cabinet : Enclosed type
Used speakers (two-way system) :
Woofer (for low tones) ............................ Oval cone type
Tweeter (for high tones) .................... 2.5 cm dome type
Nominal impedance ..................................................... 8
Ω
Frequency Range ..................................... 60 to 20,000 Hz
Sensitivity ................................ 82 dB/W (at 1 m distance)
Permissible input :
Max. input ............................................................... 12 W
Rated input .............................................................. 4 W
Crossover frequency ................................................ 3 kHz
External Dimensions ....... 74 (W) x 630 (H) x 101 (D) mm
Weight ..................................................................... 1.6 kg
Accessory parts (for 2 speakers)
.............................................................. Speaker cable x 2
............... Speaker mounting fittings (for top left side) x 1
............. Speaker mounting fittings (for top right side) x 1
....................... Speaker mounting fittings (for bottom) x 2
...................................... Flat countersunk head screw x 4
....................................... Hexagon socket head screw x 4
..................................... Mounting tool
(Hex wrench) x 1
................................................ Operating Instructions x 1
Published by Pioneer Corporation.
Copyright © 2001 Pioneer Corporation.
All rights reserved.
CABINET MAINTENANCE
÷ Use a polishing cloth or dry cloth to wipe off dust and
dirt.
÷ When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
They may damage the surface of the cabinet.
÷ Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will cor-
rode the surfaces.
÷ When a chemical cloth is used, read the cautions for the
chemical cloth carefully.