Prince Castle TX-208 - Manual (Page 3)

3
TOASTER
TX-208
Operation
1
Power On/Off Button
Display
Temperature LED’s
Press the On/Off Button to turn the unit on.
The conveyor will begin to turn
and the display will read “
L LO O ”.
When the unit is at operating
temperature the display will
read “
R RD DY Y ” and the ACT (actual
temperature) LED will be lit.
2
Turn the Bun Thickness Adjustment Knobs to the desired setting.
R R D D Y Y
Power On/Off Button
If the heater is above 450°F, the
display will alternately show
“
C CO OO OL L ” and “ O OF FF F ”, and the con-
veyor belt will continue to run
approximately 45 minutes. When
the unit has cooled sufficiently,
the display will go blank and the
conveyor motor will turn off.
Left Side Control
1 = Thinnest Cut
6 = Thickest Cut
Right Side Control
A = Thinnest Cut
F = Thickest Cut
3
Feed the buns into the bun chute, flat (toasted) side up.
4 Press the On/Off Button to turn the unit off.
Bun Chute
NOTE: Factory preset temperature is 570°F and should provide satisfactory results in most applications. Maximum
temperature of unit is 580°F (304°C).
537-511revC Printed in USA 2/06 © 2006