Philips Norelco HP6319 - Manual (Page 2)

Before Using Your New Norelco Razor
◗ This appliance is intended for household use
only, as described in this manual.
◗ Before using, check foil for wear or damage. If
the foil shows signs of wear or damage, do not
use the Razor as injury may occur. Do not use it
until the foil has been replaced.
◗ For wet shaving, you may wish to prepare your
skin with soap or shaving cream before shaving.
◗
For dry shaving, be certain that your skin is clean.
If you have sensitive skin, you may wish to apply
talcum powder before and/or after shaving.
◗
When shaving your legs, underarms, or bikini line,
it is not necessary to press hard to get a close
shave. Pressing too hard may cause skin irritation,
and the Razor will not function properly. In
addition, do not use deodorant or alcohol-based
lotions immediately before or after shaving.You
may, however, want to use talcum powder.
◗
Clean the Razor regularly, for instructions see
chapter 'Cleaning'.
◗ Only the Razor, not the charging base, can be
submerged in water; however, do not submerge
the Razor for extended periods of time.
◗ You may wish to store the Razor with the
charging base connected to the outlet, so that
the Razor is kept fully charged. However,
remember to allow the battery to totally deplete
charge every 4 weeks (see chapter TO
CHARGE/RECHARGE).
To Change/Recharge
◗ Charging and recharging your Razor requires a
full 16 hours.
◗ Charge the Razor only with the charging base
provided.
◗ Be certain hands and Razor are dry before
charging.
◗ Recharge at temperatures between 40ºF and
90ºF. Charging at lower or higher temperatures
adversely affects the lifetime of the battery.
1 Be certain the Razor is in the Off (o) position
(fig.1).
2 Plug the adaptor into any 120V AC outlet. The
pilot light on the adaptor goes on (fig. 2).
3 Insert the small plug into the charging base
(fig. 3). Use only the charging base provided.
◗An adaptor plug and converter may be necessary
for the use of the charging base plug in some for-
eign countries. Use an attachment plug adaptor of
the proper configuration for the power outlet.
4 Put the Razor onto the charging base (fig. 4).
5 Charging requires 16 hours. This Razor model
HP6319, is for cordless shaving only.
6 Razor may be continuously charged with
charging base connected to electrical outlet for
a maximum of 4 weeks.At the end of 4 weeks,
you must allow the battery to totally deplete
charge before recharging.
- To deplete charge, shave in usual manner;
however, do not recharge Razor between shaves.
Continue to use Razor until battery is totally
depleted.
7 You may then keep Razor continuously
charging for another 4-week period before you
must once again allow Razor to totally deplete
charge.
IMPORTANT:
Before connecting Razor to charging base, be cer-
tain Razor is in Off (“O”) position. While Razor is
charging, the recharge light on the adaptor will light
with Razor in either the On or Off position, howev-
er, your Razor will only recharge if Razor is turned
off.
Lift & Shave Shaving System
Your new Ladyshave Razor features the Lift & Shave
Shaving System with 2 settings to choose from. The
low setting is for short hair or daily shaving. The lift
setting shaves long and short hairs close with one
quick stroke in any direction.
1 Turn the Razor on (“1”) (fig. 5).
2 Hold the Razor so that Shaving Head is in full
contact with your skin. Shave with smooth,
steady strokes, against the direction of hair
growth.
◗ Pressing too hard may cause skin irritation.
◗ Practice is best for optimum results.
◗ Make sure both trimmers and shaving foil are in
complete contact with skin.
◗ For shaving underarms, lift your arm until skin
under arm stretches slightly (fig. 6).
◗ For shaving bikini line, stretch skin taut with your
fingers (fig.7).
◗ For shaving legs, shave with smooth, steady
strokes (fig. 8).
◗ When shaving hard-to-reach areas or longer
hairs, push the Lift & Shave slide switch upwards
to the “lift” position (fig. 9).
3 Turn the Razor Off (“O”).
Tips
◗ When shaving underarms, do not use deodor-
ant or alcohol-based lotions immediately
before or after shaving. You may, however,
want to use talcum powder.
◗ Shave by moving the razor in the direction of
hair growth. Remove any remaining hairs by
moving the razor in different directions.
◗ You may store your razor in the shower or bath
by using the convenient shower hanging loop.
Attach the shower loop to the Razor as shown
(fig. 10).
Cleaning
◗ Regular cleaning guarantees better shaving
results.
◗ It is recommended that you replace your shaving
foil once a year.
◗ Always switch Razor Off and remove charging
base plug from outlet before cleaning.
◗ Never remove or replace Shaving Head while
motor is on.
◗ Do not apply pressure or touch Shaving Head
with hard objects as this may dent or damage
foil or trimmers. If damage occurs, replace foil.
B Check foil regularly.
B Never use a razor with a damaged or broken foil.
After Each Use
◗ After each use, Razor should be quickly cleaned
by rinsing under running water or dipping and
shaking gently in water.
IMPORTANT: DO NOT keep Razor submerged
in water for a long period of time.
Once A Month - Cleaning Shaving Head
IMPORTANT: DO NOT apply pressure to
Shaving Foil.
1 Switch Razor Off (“O”).
2 Remove the shaving head bracket (fig. 11).
3 Remove the shaving unit (foil and cutter) by
grasping the two fixed trimmers on either side
of the foil and gently pulling the shaving unit
from the Razor. Once the shaving unit is
removed, hold the shaving unit only by the
trimmers (fig. 12).
◗ The Shaving Foil is very delicate and should not
be handled.
◗ If foil becomes worn or damaged, replace it. Do
not apply pressure to shaving foil.
4 Hairs can be removed from the shaving unit
and housing by rinsing clean, using a soft brush
or by lightly blowing out hairs. Be sure you
also brush hairs away from under the trimmers.
5 Brush the hair chamber (fig. 13).
NOTE: Avoid using brush on Shaving Foil, as
this may cause damage.
◗ Body of Razor and Shaving Head, including
Shaving Foil, may also be rinsed under running
water to remove hairs.
◗ Do not use or clean razor with water hotter
than shower temperature.
6 Be sure all parts are dry before reassembling.
◗ Do not use cloth or towel to dry Shaving Foil or
cutter block; allow to air dry.
7 Replace the cutter block and Shaving Head by
gently pressing back into position on Razor
body.
◗ Hold Shaving Head by plastic housing only.
◗ Always replace Protective Cap on shaving head
to prevent damage to foil (fig. 14).
NOTE: Use cold or lukewarm water. Never use
cleaners such as alcohol, nail polish remover,
corrosive detergents or scouring pads.
◗ For best shaving performance, it is suggested to
lightly oil Shaving Head twice a year by spreading
a drop of mineral oil over the foil and trimmers
(fig. 15).
If this does not improve the performance of your
razor, it may be time to replace the foil.
◗ Never immerse charging base in water or other
liquid.You may clean by wiping with a damp
cloth.
This razor has no other user-serviceable parts.
Any other service should be performed by an
Authorized Norelco Service Location.
STORAGE
◗ Be sure Razor is turned off. Removed cord from
outlet and charging base before storing in a safe,
dry location where it will not be crushed,
banged, or subject to damage. Do not wrap
cord around Razor or charging base when
storing.
◗ Razor may be conveniently stored by hanging
loop in shower or bath (fig. 10).
◗ Store cord in a safe location where it will not be
cut or damaged.
◗ Do not place or store charging base where it
can fall or be pulled into a tub or sink, water or
other liquid while plugged in.
Assistance
◗ For assistance or the Authorized Norelco
Service Location nearest you, call toll free:
1-800-243-3050 or visit our Norelco website:
www.norelco.com
◗ Authorized Norelco Service Location
information is available 24 hours a day, 7 days a
week.
Battery Removal
THIS NORELCO RAZOR CONTAINS A
NICKEL-CADMIUM RECHARGEABLE
BATTERY WHICH MUST BE DISPOSED
OF PROPERLY.
◗ Battery should only be removed when razor is
to be discarded.
◗ Remove razor from charging base and unplug
charging base from outlet before dismantling.
◗ All servicing should be performed by an
Authorized Norelco Service Location
How To Remove Rechargeable Battery
1 Remove razor from charging base and unplug
base from outlet before dismantling. Let the
razor motor run until the battery is completely
empty/depleted.
2 Pull firmly to open the Razor (fig. 16).
3 Using a narrow flat blade screwdriver, lift the
battery out of the Razor and then separate the
battery from the razor (fig. 17).
4 Remove battery. Do not attempt to replace
battery. Insulate battery ends by covering with
tape and/or place battery in small plastic bag.
5 Discard your razor. Do not attempt to place
the razor in the charging base and recharge the
razor after the battery has been removed.
6 Contact your local town or city officials for
battery disposal information or call 1-800-8-
BATTERY for battery drop-off locations.
Accessories
For maximum performance, replace your Norelco
Ladyshave foil and cutter block once a year
-
Model HP6119 Philips replacement foil
- Model HP6111 Philips cutter block
Razor accessories may be purchased at a store near
you, an authorized Norelco Service Location, on our
website www.norelco.com or by using the handy
order form enclosed.
Full Two-Year Warranty
Philips Electronics North America Corporation warrants each new Norelco
Product, Model HP6319 (except foil and trimmers), against defects in materials
or workmanship for a period of two years from the date of purchase, and
agrees to repair or replace any defective product without charge.
IMPORTANT:This warranty does not cover damage resulting from accident,
misuse or abuse, lack of reasonable care, the affixing of any attachment not
provided with the product or loss of parts or subjecting the product to any
but the specified voltage.* Use of unauthorized replacement parts will void
this warranty.
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION
WILL NOT PAY FOR WARRANTY SERVICE PERFORMED BY A
NON-AUTHORIZED REPAIR SERVICE AND WILL NOT REIM-
BURSE THE CONSUMER FOR DAMAGE RESULTING FROM
WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED
REPAIR SERVICE. NO RESPONSIBILITY IS
ASSUMED FOR ANY SPECIAL, INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES.
In order to obtain warranty service, simply take or ship the product postage
prepaid to the nearest Authorized Norelco Service Location. It is suggested
that for your protection you return shipments of product by insured mail,
insurance prepaid. Damage occurring during shipment is not covered by this
warranty.
NOTE: No other warranty, written or oral, is authorized by Philips Electronics
North America Corporation.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state. Some states do not allow the exclusion or limi-
tation of incidental or consequential damages, so the above exclusion and limi-
tations may not apply to you.
*Read enclosed instructions carefully.
Manufactured for:
Norelco Consumer Products Company
A Division of Philips Electronics North America Corporation
1010 Washington Blvd., Stamford, CT 06912-0015
RAZOR MADE IN AUSTRIA.
CHARGING BASE MADE IN CHINA.
Norelco is a Registered Trademark of Philips Electronics North America
Corporation.
Ladyshave & Design, Ladyshave and Lift & Shave are Trademarks of Philips
Electronics North America Corporation.
PHILIPS and Philips Shield are Registered Trademarks of Koninklijke Philips
Electronics N.V.
z 2004 Philips Electronics North America Corporation. All Rights Reserved.
This symbol on the product’s nameplate means it is
listed by Underwriters’ Laboratories, Inc.
®
LISTED
HP6319 2/17/04 11:28 AM Page 2 (Black plate)