Panasonic AG-3DA1P - Manual (Page 33)

Shooting
33
Protecting SD Memory Cards
Move the write-protect switch on the SD Memory
Card to the “LOCK” position to prevent recorded
contents being accidentally erased from the card.
LOCK
Write-protect
switch
Repairing SD Memory Cards
Never remove the SD Memory Card or
disconnect the battery or DC cable’s battery
connector while the SD Memory Card access
lamp is flashing, as doing so may damage the
SD Memory Card. In the event that the SD
Memory Card has been removed while the SD
Memory Card access lamp was flashing, or
that the battery or DC cable’s battery connector
has been disconnected during recording or
the recording finalization process, a repair
verification screen will be displayed the next time
the power is switched on in order to allow errors
to be repaired.
In this case, use the AVCCAM Restorer contents
repair software to repair the errors.
Removing SD Memory Cards
1
Tilt the viewfinder upwards, and open the
SD Memory Card slot cover by sliding the
OPEN lever to the right.
Ensure that the SD Memory Card access
lamps are not flashing before opening the
cover.
2
Press the center of the SD Memory Card
so that it pops out slightly, and pull the
card straight outwards.
2
1
SD Memory Card
access lamps
Do not remove the SD Memory Card
or switch off the power in the following
circumstances. Doing so may damage your
SD Memory Card.
1) While the SD Memory Card access lamp
is still flashing after an SD Memory Card
has been inserted.
) While the SD Memory Card access lamp
is flashing such as during recording or
during recording finalization.
It is recommended that you note “Right” or
“Left” on the SD Memory Cards. If the left
and right SD Memory Cards are inserted in
the wrong respective slots, CHECK CARD
LEFT/RIGHT is displayed on the viewfinder
and LCD monitor.
•
•
•