Adjusting the white balance, White balance adjustments, Using presets – Panasonic AG-3DA1P User Manual

Page 40

Advertising
background image

40

Adjusting the white balance

In order to reproduce the white accurately, adjust
the ratio between the three RGB primary colors.
If the white balance is not adjusted properly,
not only will the white be reproduced poorly but
the color tones of the entire screen will also be
downgraded. When you are shooting in manual
mode, readjust the white balance whenever
lighting conditions change.
You can save adjustments and reselect them by
setting the WHITE BAL switch to A or B.
You can also use the preset values.
Use the settings to suit the shooting conditions.

B

A

BARS

SHUTT

ER

AUDIO

SPEED

INPUT

MIC PO

WER +

48V

(R)

1

2

SEL

WFM

SELECT

CH 2

INT

ON

OFF

INPUT 2

(L)

INT
INPUT 1

INPUT 2

AWB button

WHITE BAL switch

White balance adjustments

1

Set the shutter speed. (Page 46)

2

Place a white pattern in a location with the

same lighting conditions and light source

as the subject, then zoom in and fill the

whole screen with white.

Something white (a white cloth or wall) near
the subject can be used instead.

Do not include bright spotlights in your
shot.

3

Set the WHITE BAL switch to A or B

(whichever one you want to save the

adjustment in).

4

Hold down the AWB button for a while.

The following messages appear on the
screen.

Message during adjustment

AWB ABB Ach

*

ACTIVE

The camera performs the white balance
adjustment and the black balance
adjustment in sequence. The adjustment
will be finished in a few seconds.

Message after adjustment

AWB ABB Ach

*

END

An error message appears on the screen
when white balance adjustment is not
possible.

Message when adjustment cannot be

done

AWB Ach

*

NG

*

Bch when the WHITE BAL switch is set to

B.

Using presets

Use this feature when you have no time to make
white balance adjustments.

1

Set the WHITE BAL switch to PRST.

The current white balance value appears.

White balance values 300 K and 5600 K
are preset in the PRST position.
Guide to the preset values
P3.K (300 K): halogen light
P5.6K (5600 K): outdoors

2

Press the AWB button.

White balance switches between 300 K and
5600 K.

Advertising
This manual is related to the following products: