Panasonic AG-3DA1P - Manual (Page 42)

4
Shooting techniques for different targets
Low angle recording
Recording can be controlled with the handle
START/STOP button during low angle recording
by moving the REC selector switch to the ON
position.
To prevent erroneous operation when not using
the handle START/STOP button, set the REC
selector switch to the OFF position.
Handle START/
STOP button
REC selector switch
•
Zebra pattern
Press the ZEBRA button in the CAMERA mode
to show the zebra pattern on the viewfinder and
the LCD monitor so you can check the brightness
of the subject.
Parts that may be whited out through over
exposure are shown as a zebra pattern.
Very bright
Reflecting parts
You can remove most overexposed parts by
adjusting the iris and shutter speed in the manual
mode to remove the areas with zebra patterns.
The display changes as follows each time you
press the ZEBRA button: OFF ZEBRA1
ZEBRA OFF …
BARS SHUTTER
AUDIO
SPEED
INPUT
MIC POWER +48V
（R）
1 2
SEL
WFM RESET COUNTER
EVF DTL MIX ZEBRA
SELECT CH 2 CH 1
INT ON
OFF INPUT 2
（L） INT
INPUT 1
INPUT 2
ZEBRA button
The zebra pattern you have set appears as a
percentage on the display for about  seconds.
In the setup menus, DISPLAY SETUP screen,
ZEBRA DETECT1 and ZEBRA DETECT, set
the brightness for the zebra patterns. (Page 81)
•
•
•