Panasonic AG-3DA1P - Manual (Page 46)

46
SHUTTER button
SPEED SEL
buttons
BARS SHUTTER
AUDIO
SPEED
INPUT
MIC POWER +48V
（R）
1 2
SEL
WFM RESET COUNTER
EVF DTL MIX ZEBRA
SELECT CH 2
INT ON
OFF INPUT 2
（L） INT
INPUT 1
INPUT 2
CH 1
1
Press the SHUTTER button.
Each time you press the SHUTTER button,
the shutter speed switches between normal
(OFF) and the speed you selected with the
SPEED SEL buttons.
SHUTTER 1/60
2
After you have pressed the SHUTTER
button, press SPEED SEL buttons to
select the shutter speed.
The shutter speed changes as follows each
time you press SPEED SEL + button (The
order is reversed for the SPEED SEL −
button.)
Remember that the faster the shutter speed,
the lower the sensitivity.
The current shutter speed appears on the
viewfinder and LCD monitor when you have
selected ON in OTHER DISPLAY in the
DISPLAY SETUP screen of the setup menus.
It is not displayed if you have set the shutter
speed to normal (OFF).
With artificial lighting and especially fluorescent
lights and mercury-vapor lamps, the luminance
changes in synchronization with the power
line frequency. When this frequency is 50 Hz,
mutual interference will occur between the
camera-recorder’s vertical sync frequency
(approx. 60 Hz) and the lighting frequency (50
Hz). This means that the white balance may
change periodically.
Before shooting in areas with artificial lighting
or adjusting the white balance, set the shutter
speed as follows.
When SYSTEM FREQ is set to 59.9 Hz
Progressive
mode
Shutter speed
50 Hz 60 Hz
OFF (60i) 1/100 OFF (1/60)
30P OFF (1/50) 1/60
4P OFF (1/50) 1/10
When SYSTEM FREQ is set to 50 Hz
Progressive
mode
Shutter speed
50 Hz 60 Hz
OFF (50i) OFF (1/50) 1/60
5P OFF (1/50) 1/60
•
•
•
Adjusting the shutter speed
When SYSTEM FREQ is set to 59.9 Hz
With the 1080/60i or 720/60P format
Standard (OFF)
1/60
SYNCRO SCAN 1/250 1/120 1/100 1/60
With the 1080/30P format
Standard (OFF)
1/50
SYNCRO SCAN 1/250 1/120 1/60 1/50 1/30
With the 1080/24P format
Standard (OFF)
1/50
SYNCRO SCAN 1/250 1/120 1/60 1/24 1/50