Panasonic AG-3DA1P - Manual (Page 48)

48
During shooting, you can record up to two
channels of sound. You can also switch the input
sound to be recorded on each of the channels to
the built-in microphones, external microphones or
audio equipment connected to camera.
BARS SHUTTER
AUDIO
SPEED
INPUT
MIC POWER +48V
（R）
1 2
SEL
WFM RESET COUNTER
EVF DTL MIX ZEBRA
SELECT CH 2
INT ON
OFF INPUT 2
（L） INT
INPUT 1
INPUT 2
CH 1
CH2 SELECT switch CH1 SELECT switch
INPUT 1/2 (MIC POWER +48V) switches
Using the built-in microphone
1
Switch the CH1 SELECT switch to INT (L).
Audio from the built-in microphone Lch is
recorded to audio channel 1.
2
Switch the CH2 SELECT switch to INT (R).
Audio from the built-in microphone Rch is
recorded to audio channel .
•
•
Switching Audio Input
Using an external microphone and
audio equipment
1
Connect an external microphone or audio
equipment to the INPUT 1/2 (XLR 3-pin)
terminals. (Page 66)
OFF 1 HANDLE ZOOM 2 3 ON
INPUT 1 terminal
INPUT 2 terminal
2
Use the INPUT 1/2 switches to switch the
audio input.
PUSH
INPUT 2 switch INPUT 1 switch
LINE: (audio equipment is connected)
Input level is 0 dBu.
MIC: (an external microphone is
connected)
Input level is –50 dBu.
You can change the input level to –60 dBu
in the setup menus, RECORDING SETUP
screen MIC GAIN1 and MIC GAIN. (Page
80)
Be aware that sensitivity will be higher if
you choose –60 dBu so you will record
more noise.