Panasonic AG-3DA1P - Manual (Page 54)

54
Recharging the built-in battery
The camera’s internal battery saves the date and
time.
When LOW INTERNAL BATTERY (indicating that
the internal battery has no remaining charge) is
displayed even when the date and time are set,
it means that the charge of the internal battery is
depleted. Do the following to recharge it.
Reset the date and time when fully recharged.
1
Connect the AC adaptor. (Page 24)
Leave the POWER/Mode selector switch
at OFF.
2
Leave the camera like this for about 4
hours.
The internal battery charges during this
time.
Check the time code and menu operations
after recharging.
If the date and time are not memorized after
recharging, the internal battery requires
changing. Please consult the place of purchase.
Setting the time code
In the setup menus, TC/UB SETUP screen, set
the following time code related items. (Page 80)
TC MODE
(Only when SYSTEM FREQ is set to 59.9 Hz)
TCG
TC PRESET
•
•
•
•
•
•
Charging the built-in battery/Setting the time code
Specifying the time code
(TC PRESET)
Set TC PRESET so you can record a value of
your choice as the initial setting for the time code
to be used at the start of recording.
1
Set the POWER/Mode selector switch to
ON.
2
Select the TC PRESET item on the settings
menu TC/UB SETUP screen.
Menu operation (Page 75)
TC/UB SETUP
TC MODE DF
TCG REC RUN
TC PRESET NO
UB PRESET NO
3
Tilt the Operation lever in the direction
to move to YES, and push the Operation
lever.
YES
NO
TC PRESET
TC MODE
TCG
UB PRESET
TC PRESET
•