Panasonic AG-3DA1P - Manual (Page 81)

Menu
81
AV OUT SETUP screen
Item
Display
mode
Description of settings
SDI OUT (Camera)
(PB)
Sets whether to output the signal from the HD SDI terminal.
ON: The signal is output from the HD SDI terminal. It is not output from the
HDMI terminal.
OFF: The signal is not output from the HD SDI terminal. It is output from the
HDMI terminal.
HP MODE (Camera) Selects the sound heard through the headphones.
LIVE: The sound which has been input from the microphone is output
as is. This setting is selected when delays in the sound are
annoying.
RECORDING: The sound in the status which is to be recorded (the sound
synchronized with the images) is output.
DISPLAY SETUP screen
Item
Display
mode
Description of settings
ZEBRA
DETECT1
(Camera) Selects the brightness level of the left-leaning zebra patterns on the screen.
105%, 100%, 95%, 90%, 85%, 80%, 75%, 70%, 65%, 60%, 55%, 50%
ZEBRA
DETECT2
(Camera) Selects the brightness level of the right-leaning zebra patterns on the screen.
105%, 100%, 95%, 90%, 85%, 80%, 75%, 70%, 65%, 60%, 55%, 50%
SAFETY ZONE (Camera) Sets whether to display the safety zone. (Page 69)
ON OFF
REC
COUNTER
(Camera) Selects counter operation during recording.
TOTAL: The count continues to increase until the RESET button is pressed
to reset it.
CLIP: Resets the counter at start of recording and counts the time of each
recording session.
In PB mode, operation is always in CLIP mode. •
OUTPUT OSD (Camera) Select ON to output the information displayed on the screen together with the
video signals.
ON OFF
Time code, audio lever meter, and focus bar displays are not output. •
DATE/TIME (Camera) Sets whether to display the date and time on the screen together with the
video signals.
TIME: The time is displayed.
DATE: The date is displayed.
TIME & DATE: The date and time are displayed.
OFF: The date and time are not displayed.
LEVEL METER (Camera) Select ON to display the audio level meter.
ON OFF
ZOOM &
FOCUS
(Camera) Sets whether to display the zoom and focus values.
ON OFF
CONVERGENCE (Camera) Sets whether to display the position of the reference plane (relative value).
(Page 38)
ON OFF
indicates the factory setting.