Plinius Audio SA-250 User Manual
Page 18
18
LED BRIGHTNESS CONTROL
Your Plinius SA-250 has an internal LED brightness control that will adjust all three front panel LED’s. A
small flat bladed screwdriver can be used to adjust the brightness. The LED brightness control is a small
multi turn potentiometer and is located on the front of the main circuit board within the top cavity of the
amplifier, and is labelled VR5. Make sure you adjust the correct potentiometer, and remember to remove
the mains supply from the amplifier before making any adjustments.
Ecologic Jumper JP4
Fuse LEDs
Error LED
LED Adjuster VR5
S
ECTION
O
F
SA-250 M
AINBOARD
S
HOWING
P
OSITION
O
F
E
COLOGIC
J
UMPERS
A
ND
L
ED
B
RIGHTNESS
A
DJUSTMENT
P
OTENTIOMETER
MAINS/LINE FUSE
A Mains/Line fuse is fitted within the IEC Mains/Line socket on the rear of the amplifier. A small drawer at
the bottom of this socket may be removed (after the IEC plug is removed) by levering it out with a flat
blade screwdriver. The fuse fitted should be rated at no greater than 20 amps normal blow.
In the unusual event that this fuse should blow, you must first establish the cause of this failure (such as
power surges, damaged mains cable etc.) before replacing the fuse with one of the same rating and type.
IMPORTANT: DO NOT FIT A FUSE WITH A HIGHER RATING.
TOWARDS
FRONT OF
AMPLIFIER