Panasonic AG-DVC200P - Manual (Page 10)

10
3
Connect the plug of the battery pack to the
connector inside the battery case, and
insert the battery pack into the case.
<Note>
The power must be turned off without fail before connecting or
disconnecting the plugs.
AU-BP402
battery pack
Label
surface
Preparations
Using the AU-BP402 or AJ-BP490 battery pack made by Panasonic
1
Remove the battery holder.
Disconnect these.
2
Install the battery case into the unit.
Battery holder
Recharge the battery pack using the battery charger specifically designed for each individual battery pack. For the charging time and other
details, refer to the operating instructions of the battery charger used.
Disconnect these.
Connect here.
Rubber caps Screws
AU-M402H
battery case
1Connect the unit’s cable with the cable of the AU-M402H
battery case.
2Use a screwdriver to install the AU-M402H battery case in
the unit.
The holes for tightening the screws can be seen when the
cover is opened and the rubber caps are raised. Use a
screwdriver to tighten the screws, and install the battery
case into the unit. Ensure that the screws are tightened up
as far as they will go.
<Note>
≥Do not pull the rubber caps with great force.
≥Be careful not to catch up the cables when installing the
battery case.
4
Set the battery type.
Select the battery type using <BATTERY> on the sub-menu
screen.
Select “TYPE A” if the AJ-BP490 is to be used; select “NiCd12”
if the AU-BP402 is to be used. (See page 34)